Koni Shock absorbers

Quote:

---

Originally Posted by uninformed

Page 1...

---

Yeah typical aulro, gone off track.

Well spoke with suspension stuff in regards to koni 90's (back on topic), they advised that they are a massive shock and most likely will not fit, but also the longest pin to pin that they could think of are approx 620mm.
So (back off topic), the amada extreme remote canister jobbys I enquired about are 382 closed, 660open, pin to pin and $1150 for a set of 4, 11" of travel :).
The next size up where 700+ open and 438 (?) Closed which is to long in the closed position for me:(

Quote:

---

Originally Posted by Vern

Yeah typical aulro, gone off track.

---

That was actually pointing slunnie to the answer to his question.

But yes going off topic in a very specific thread has shown itself by slunnie question.

4wd action article on 100 series cruiser shocks. It features Koni, Bilstein, rancho etc etc.
Quite a thorough article including open/closed measurements for each and dyno charts.

[ame]http://www.euro4x4parts.com/images/4wd_action_165_tough_dog.pdf[/ame]

Quote:

---

Originally Posted by rick130

Serg has a pair of 88 Series on the rear and I can't recall him ever mentioning them fouling anywhere.

Beadell tours run 90 Series all round on their 110 and rave about them on their website.
Maybe a case of sponsorship ?

Haven't rung Superior yet, just drafting an email for some specific diff lube for a certain locker and finalising an order from Karcraft.

[edit] Just emailed Superior/Profender requesting open/closed lengths. Will try and ring tomorrow.

---

Any luck with superior yet rick? I rang them today in regards to front arms and Amada's, they said they will get back to me.

Quote:

---

Originally Posted by Vern

Any luck with superior yet rick? I rang them today in regards to front arms and Amada's, they said they will get back to me.

---

No reply to the email yet and I was too damned busy to ring today.

Will try and ring tomorrow.

OK will post up what I find out from them, I'm enquiring about an 11" stroke (min)and 400mm closed length, pin to pin and valved to suit:)

Well Rick??
I didn't get my call back today:(

Still waiting! How did you get on rick?.

I didn't call but they haven't return emailed me either :(