Thread: Hacking a socket to make a tool-S3

Or use a brass drift.

Aaron

Grinder will get through it fine.

do people use a gasket when putting the cover back on or just goo?

about to play the same game...

Paper gasket and Permatex avaition form-a-gasket #3.

Aaron

part number 622047

ta

an angle grinder with a cutting wheel will do the job BUT... you will find that either a 100 or 125mm grinding wheel (I forget which) is the same thickness as the gap you need to grind so skip the cutting wheel to start with and plough in with a new grinding wheel. then use a cutting wheel or hand file to finesse the edges.

if you go the brass punch option have at it through the top inspection port from between the seats. Make sure to engage high range and 1st gear then roll the vehicle backwards so all the slack is out of the driveline and gearbox if possable have someone hang off of the crank handle out the front or at least put a reaction bar on the alternator nut to help hold everything in place so you dont have the drift jump due to the gears moving. (it also helps get a good hit on the nut)

from memory the nut gets done up to 80ftlb.

you can use the paper gasket with hylomar #3 (aviation formagasket non hardening #3 or that sticky brown stuff that gets everywhere) or you can use an oil resistant sealastic. The bearing in the cover is a needle roller so its distancing is not vital.

Thanks everyone, especially Dave for that comprehensive reply. Will put the grinding wheel on and get on with it.
Cheers

Coop

Originally Posted by Blknight.aus

an angle grinder with a cutting wheel will do the job BUT... you will find that either a 100 or 125mm grinding wheel (I forget which) is the same thickness as the gap you need to grind so skip the cutting wheel to start with and plough in with a new grinding wheel. then use a cutting wheel or hand file to finesse the edges.

if you go the brass punch option have at it through the top inspection port from between the seats. Make sure to engage high range and 1st gear then roll the vehicle backwards so all the slack is out of the driveline and gearbox if possable have someone hang off of the crank handle out the front or at least put a reaction bar on the alternator nut to help hold everything in place so you dont have the drift jump due to the gears moving. (it also helps get a good hit on the nut)

from memory the nut gets done up to .

.

I've tried that with limited success. 1.You need a top quality socket, a cheap one won't be strong enough after you cut out all the notches . 2. It's got to be a deep socket to clear the shaft.
I doubt that you can tighten that nut to 80ftlb with a brass drift. Pieces of brass will break off before you reach that figure. If that nut is not tight enough it will work itself loose ,eventually breaking off the tab on the locker which then gets chewed up by the gears and bearings. But if you want to use your gearbox for only a few thousand kms,I reckon you will get away with it.
I ended up making my own socket, not pretty but it works , and tightened that nut to 100 ftlbs by mistake.
.W.