Help - 16mm wheel studs for trailer

Have been in touch with Melbourne land rover and they can supply a set of ten cheaper than what I found on ebay and I can pick them up tomorrow. Ill let you know if it all goes well!

Quote:

---

Originally Posted by MR LR

Trailer hub suppliers won't do it, period.

Take them to any engineering shop and get the holes drilled and the studs pressed in, unless you have a mill and press like we do, then it's a half hour job!

Cheers
Will

---

Actually the trailer parts place here in Tullamarine fitted Landy studs to trailer hubs for Landover.

I change the 5/8 studs for toyota 100 series cruiser studs. just use a punch, spline is same size.

Quote:

---

Originally Posted by JDNSW

5/8" is 0.125mm smaller. Not much, but of course, the concern is to have the same spanner size.

John

---

Thanks John, wasn't sure of the bolt shank size, as I often use Metric and AF tools, I will often use a 16mm socket/spanner on a 5/8 nut/bolt head and vice versa, Regards Frank.

Quote:

---

Originally Posted by loanrangie

Actually the trailer parts place here in Tullamarine fitted Landy studs to trailer hubs for Landover.

---

Yes but manufacturers like alko won't do it, which is where most off the shelf stuff in Aus comes from.