Page 1 of 3 123 LastLast
Results 1 to 10 of 27

Thread: 2T van - 1 or 2 axles

  1. #1
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0

    2T van - 1 or 2 axles

    For an off-road van approaching 2T GVM, what are the significant pros and cons of single vs dual axles? I favour a single axle but perhaps 4 wheels are sometimes or often better than 2.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  2. #2
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    Twin axle trailers are good on smooth roads, everywhere else a single axle will give you a better ride. Twin axle trailers put a lot of stress on your tow bar once you reach the limits of the axles articulation. Single axle trailers are also much easier to maneuver by hand using a jockey wheel.

  3. #3
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    I should have stated for a van to be used on outback roads rather than an off-road van, so travelling over pot-holes and bumps rather than true off-road conditions.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  4. #4
    Join Date
    Apr 2009
    Location
    South Sydney
    Posts
    2,499
    Total Downloaded
    0
    Our car trailer is single axle, 2500kg, I won't go back unless I need to go bigger. Tows like a dream on sealed and unsealed roads.

    I'd go with single, but make sure it has a big axle and big bearings, and decent wheels and tyres. Primarily just because I much prefer how they tow, and it keeps weight down.

  5. #5
    Join Date
    May 2011
    Location
    Wyndham Vale. Vic.
    Posts
    624
    Total Downloaded
    0
    It depend on personal preference, but if you go tandem make sure it's independent coils.

  6. #6
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    The thing is, 2T isn't all that much for a single axle, if you use a quality set of hubs to fit 16" 4WD wheels. Match that with quality springs and some shock absorbers and your trailer will follow everywhere without any fuss. All of my trailers that I've built and owned over the last 35 years have been built to that pattern and they are far superior in towing comfort compared to the tandems I've had the misfortune to borrow.

  7. #7
    Join Date
    May 2008
    Location
    Bundaberg Qld
    Posts
    7,036
    Total Downloaded
    0
    If a tyre lets go (dramatically) on a single axle anything, the resulting ride is a little more exciting. I have had a few go over the years on dual axle trailers with no major side effects.

  8. #8
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    Quote Originally Posted by pop058 View Post
    If a tyre lets go (dramatically) on a single axle anything, the resulting ride is a little more exciting. I have had a few go over the years on dual axle trailers with no major side effects.
    When I've had flats on my single axle car trailer I haven't noticed a thing until the tyre started shredding the mud guard. The trailer weight balance doesn't change at all. A flat on the rear of a tandem however can lead to wild swaying and a massive brown stain on your seat. I've seen that more than once.

  9. #9
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    We're starting to think about a replacement van. Our current one is an old 14' Coromal to which I've fitted long off-road leaf springs and shocks and 30" tyres and it now rides rough gravel roads very well, although it only weights about 1T. The van's main deficiency is its lack of an en-suite but extra space and a longer bed would also be good.

    We looked at some new Jayco Outbacks that have a single axle for the slightly smaller ones and duals for the next size up. I wondered if independent coil suspension duals might ride bumps better, acknowledging that 4 wheels hitting bumps could be worse than 2. I'm keen to keep the weight down but less impact felt by the tow vehicle is better.

    We're also contemplating the pros and cons of pop-top vs caravan.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  10. #10
    Join Date
    May 2008
    Location
    Bundaberg Qld
    Posts
    7,036
    Total Downloaded
    0
    Quote Originally Posted by bee utey View Post
    When I've had flats on my single axle car trailer I haven't noticed a thing until the tyre started shredding the mud guard. The trailer weight balance doesn't change at all. A flat on the rear of a tandem however can lead to wild swaying and a massive brown stain on your seat. I've seen that more than once.
    I was referring to one letting go in a hurry, not just deflating and I have not experienced the major swaying (or staining ) when I have lost a front or rear on my trailers. Lucky I guess.

Page 1 of 3 123 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!