Thread: Disc Hubs

I have been wondering if these would fit. They are off a BMW X5 but the same PCD and it looks like the rims would just bolt on to a D2.

http://www2.partstrain.com/store/pro...name=wheel_hub

Originally Posted by dobbo

I have been wondering if these would fit. They are off a BMW X5 but the same PCD and it looks like the rims would just bolt on to a D2.

http://www2.partstrain.com/store/pro...name=wheel_hub

I don't know if the hub fits, but the rims will, also VW will as well as they have 120PCD.

They may have the same PCD but what about the ABS sensor.

Baz.

Originally Posted by Redback

I don't know if the hub fits, but the rims will, also VW will as well as they have 120PCD.

They may have the same PCD but what about the ABS sensor.

Baz.

The X5's ABS/TC system was straight out of a Rangie wasn't it?

Originally Posted by dobbo

The X5's ABS/TC system was straight out of a Rangie wasn't it?

Don't know, the P38a Rangie is different too the D2 though.

This is a link to my project for using Commodore trailer disc hubs to match the wheels to the towing vehicle my Disco 2.

http://www.aulro.com/afvb/showthread.php't=43201

Baz.

Originally Posted by Redback

I scored some trailer disc hubs and calipers in Commodore pattern for the camper, they have holden bearing in them and i want to change them to the heavier duty Ford bearings will they fit these hubs, is it only the inner hole diameter that's different.

Baz.

Baz

Was in Caravan Accessories on Tuesday asking about hubs etc and yes the Holden bearings can be replaced by Ford (slimline) bearings. The bit that is not interchangeable is the axle.

Hope this helps

Diana

yep what lot za said.
the outer diameters of both LM and SLM bearings are the same its just the inside diameter thats different.

cheers phil