Anyone able to help with some dimensions of the Treg Hitch. Mine is in a container on a ship on its way to Dubai and I am in need of the dimensions so as to have a tow bar made for the LR3. The models here are Euro spec and the Aussie fittings won't work.
If anyone is able to help I need the following:
The Diameter of the threaded bolt that goes through the tow bar tongue:-
The distance between the pieces of metal (don't know the tech names) that go either side of the tongue:-
The height of the Treg when sitting on the tongue, with the pin, with the spring installed (for clearance for when the lower back door is in the full open position):-
Any assistance would be greatly appreciated so as I can get this made and tow the Trak Shak off the docks when it arrives.
Thank you
Master
G'day
The locating tabs on the bottom are 78mm apart, the hayman reece reciever on mine is 76mm wide.
The bolt hole is 22mm or 7/8 inch.
The height of my pin (T bar top) including spring is 160mm.
Hope this helps, if you need a photo just let me know.
Rob
Rob,
Thanks very very much for the info. A photo would be great as well if possible. Also could you tell me how thick the tongue steel is?
Much appreciated
Ian
Master
Tongue is a bit over 20mm thick (doesnt even match imperial)
Here is a link to some photos that may be usefull
http://www.trailerwarehouse.com.au/i...rget=d218.html
Rob
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
AULRO.com Copyright 2001 - 2025 Independently Owned and Operated by Dave Blears Computing - DavecandoIT - AULRO.com LAND ROVER and its logo are the registered trademarks of Land Rover. Land Rover is not affiliated with AULRO.com. |
|
Reply With Quote
Bookmarks