Results 1 to 3 of 3

Thread: D1 rims and parrallel bearings

  1. #1
    Join Date
    Oct 2006
    Location
    Somerville
    Posts
    124
    Total Downloaded
    0

    D1 rims and parrallel bearings

    Is it possible to get a hub to fit D1/Landy rims onto a parrallel bearing 45mm stub axle?

    Who would be able to set me up in Melbourne?>

  2. #2
    Join Date
    Sep 2008
    Location
    Geelong, VIC
    Posts
    4,442
    Total Downloaded
    0
    a few years back I got a couple of trailer hubs to suit some Sigma alloy wheels I had at the time.
    I just went into a local trailer place, gave them the PCD and wheel stud size etc and they ordered them in for me. Only cost about $50 for the pair complete with bearings.
    These guys do hubs in Landrover sizes AL-KO Australia : Vehicle Technology : Products

    Steve
    Last edited by steveG; 10th February 2009 at 08:12 PM. Reason: additional information

  3. #3
    Join Date
    Jan 1970
    Location
    Avoca Beach
    Posts
    14,152
    Total Downloaded
    0
    Sigh, I f you do a search you may find my post from about 2 years ago where I wanted to use my RRC mags on my camper.

    In summary, you buy the drums from ALKO without holes and then buy RR /Disco 16MM studs and have a local shop drill the PCD. You have to countersink the holes a bit to get the correct emerged length.

    If you do not care about mags, ALKO will supply the hubs drilled to PCD but with 9/16 studs and nuts.
    Camec can supply them at retail.
    Regards Philip A

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!