Mud Flaps

[defender90]

Need info or part numbers for some new rear mud flaps on my 2003 90 as it is a 1 point and $70 fine for "Driving a motor vehicle that is not fitted with equipment required by the vehicle standards"
cheers

[discowhite]

i make mine,
clark rubber has insertion rubber that will out last the LR ones.
unless you want the LR symbol??

cheers phil

[defender90]

got any photos of ya flaps. i also have to replace the brackets too. my dog got a little hungry and ripped the lot off, sheared one bolt and just destroyed the rest of the holes in the brackets on both sides!

[Rosco]

got any photos of ya flaps. i also have to replace the brackets too. my dog got a little hungry and ripped the lot off, sheared one bolt and just destroyed the rest of the holes in the brackets on both sides!

Some dog ...........

[waynep]

my dog got a little hungry and ripped the lot off, sheared one bolt and just destroyed the rest of the holes in the brackets on both sides!

jeez... scary dog

[Rosco]

.....
clark rubber has insertion rubber ......
cheers phil

Please explain ........ OR GO TO THE MUD PIT !!!!!!!!!

[discowhite]

i keep bending my brackets, to many steep angles around here
my flaps are an almost exact copy of the LR ones, slightly wider(to the outside of the car) and slightly longer, to allow for my 3'' lift.
so there wider by 25mm and longer by 40mm.

as for your destoryed holes, i had to re install some of the rivett nuts to re fit my brackets (i have the rivett nut tool)
other than that next time i'll be looking at attaching my flaps the the rear of the crossmember, no brackets to rip off

cheers phil

flaps up


flaps down

[discowhite]

Originally Posted by discowhite
.....
clark rubber has insertion rubber ......
cheers phil

Please explain ........ OR GO TO THE MUD PIT !!!!!!!!!

ATTENTION!!!sicko's
this post has nothing to do with sclarke!
and yes i mention insertion and flaps alot in this post.

cheers phil

[defender90]

cheers phil your 90 looks tops wanna swap

[CraigE]

Truck mudflaps from a local truck repairer / workshop. Cheap and a lot stronger than LR. Only issue is most of them are advertising. Have a look in the gallery at mine. Keep the existing frames and drill out the rivets and reuse.