Thread: MULGO's PUMA X-Box

Thanks for that however I've already made the cut. Fortunately this also removed the need for another hole in the base of the ex box.
Also the last of the pumas produced have a deeper wiring loom and as such the attachment points of circuit/CB board needs to be raised by 30mm on far left and 60mm on single point on right otherwise the wires beneath the board are compressed and rub on base of ex box.

Originally Posted by Rolly

Thanks Toxic,

Unfortunately it wasn't just the wires I was trying to get through but also the plug....it were mission impossible.
Combined with this there was not enough length for the loom to enter the ex box and reach the bass box. I'll extend it and world is good again.

Cheers

Oh yeah, forgot about that plug. Its impossible to feed through, its too huge. Hence the cut.