Page 2 of 5 FirstFirst 1234 ... LastLast
Results 11 to 20 of 50

Thread: Centre Diff Lock

  1. #11
    Join Date
    Feb 2010
    Location
    Stellenbosch, Republic of the Western Cape, RSA
    Posts
    662
    Total Downloaded
    0
    Quote Originally Posted by Drew90 View Post
    Currently I only use them when I need to, but have heard people talking about having them on all the time over slippery terrains. What's the proper story?
    As soon as you leave tar, engage CDL and reduce tyre pressures.

  2. #12
    Join Date
    Oct 2010
    Location
    Ourimbah
    Posts
    409
    Total Downloaded
    0
    I always engage the centre diff lock (CDL) when on technical tracks.

    Please correct me if this wrong; Worst case:

    CDL not engaged: 1 wheel turns
    CDL engaged: 1 wheel turns at front, 1 wheel turns at back
    Rear Diff Locker engaged: Both wheels turn at back (if you have one)
    Front Diff Locker engaged: Both wheels turn at front (if you have one)

  3. #13
    Join Date
    Feb 2010
    Location
    melbourne
    Posts
    100
    Total Downloaded
    0

    Trans.

    Quote Originally Posted by Naks View Post
    As soon as you leave tar, engage CDL and reduce tyre pressures.
    X2 I just had my trans case rebuilt as a consequence of previous owner not locking ctr diff enough on gravel, or basically anything that wasnt sealed. Flogged out ctr diff bearing and thrust washers as its not designed to be loaded with uneven drive while off road. Was told its better to use it too much than not enough. Rebuild also made huge improvement to drivetrain backlash and hard gear changes.

  4. #14
    Join Date
    Aug 2006
    Location
    WA
    Posts
    13,786
    Total Downloaded
    0
    Quote Originally Posted by Beckford View Post
    I always engage the centre diff lock (CDL) when on technical tracks.

    Please correct me if this wrong; Worst case:

    CDL not engaged: 1 wheel turns
    CDL engaged: 1 wheel turns at front, 1 wheel turns at back
    Rear Diff Locker engaged: Both wheels turn at back (if you have one)
    Front Diff Locker engaged: Both wheels turn at front (if you have one)
    Yes,
    Yes,
    If you have CDL disengaged, but a front OR rear locker engaged, then one of the wheels on the unlocked axle will turn and you will be no better of than having no locker.

    one Locker + CDL engaged, then you will aways have at least 3 wheels turning.

    F+R locker but CDL disengaged, then only 2 wheels on one of the axles turning (again worst case - e.g. when climbing a steep hill, drive will go to the front as it will have less load).

  5. #15
    Join Date
    Nov 2008
    Location
    where every one holidays, sunny coast
    Posts
    1,712
    Total Downloaded
    0
    iv tryed with and without on dirt rds,, if i feel it sliding about and that,, i just slow down

    i only put cdl in if i recon theres gona be a chance of wheel lift, and if it looks hectic enof then the locker gose on,

  6. #16
    Join Date
    Jan 1970
    Location
    Nanny state UK...
    Posts
    3,253
    Total Downloaded
    0
    Quote Originally Posted by isuzurover View Post
    Conversely, I (and many others) engage my rear locker (as well as CDL) when going down steep slopes or traversing sidslopes offroad.

    With the CDL engaged, if you get crossaxled while going downhill then the vehicle will race forward. With no CDL, only one wheel has to lift for the same to happen.

    With CDL+rear locker, as long as at least 1 rear wheel is on the ground, you will have an even rate of descent and the vehicle will track straighter.

    (n.b. This is on a vehicle without HDC/ETC - however the same should still apply).
    The Defender doesn't have HDC anyway...

    Without the locker, lifting a wheel will cause the wheel to rotate backwards, the vehicle will surge forwards and when the wheel comes back in contact with the ground it has the potential to damage the axle.

    In this type of scenario, you are taught to feather the brake slightly as that will help prevent the wheel from rotating backwards.

    ...and FWIW - I'll engage CDL when I'm on any loose surface. The important bit is to make sure you disengage before you hit the black stuff!!

    M

  7. #17
    Join Date
    Jan 1970
    Location
    NSW far north coast
    Posts
    17,285
    Total Downloaded
    0
    Oh well, I'm the odd one out (again) as I only use the CDL when i need it. ie. real 4WDing where one may lift a wheel or spin a tyre.

    portafilter, I drive loose gravel all the time and never bother with the CDL and the car has 280,000km ATM.
    The t/case is still holding up and drives ok (which I'm surprised at as it had different tyre sizes front/rear when I bought it with 76,000km on the clock. The t/case fluid was black from being overheated)

    I can imagine burning up the centre diff if the CDL isn't used in really loose/muddy conditions or lifting wheels and the driver just keeps the right foot into the firewall but on a normal gravel/dirt/shale road ?

  8. #18
    Join Date
    Jul 2006
    Location
    Tumbi Umbi, Central Coast, NSW
    Posts
    5,768
    Total Downloaded
    0
    That makes two of us Rick.

    I had been led to believe that what destroyed the centre diff was either the front prop shaft and rear prop shaft turning at significantly different speeds for a considerable time (eg one wheel allowed to spin a lot) or the two prop shafts turning at slightly different speeds and suddenly being made to turn at the same speed (eg a spinning wheel suddenly getting grip).

    Neither of those things happens if you drive sensibly on dirt roads.

    1973 Series III LWB 1983 - 2006
    1998 300 Tdi Defender Trayback 2006 - often fitted with a Trayon slide-on camper.

  9. #19
    Join Date
    Aug 2006
    Location
    WA
    Posts
    13,786
    Total Downloaded
    0
    Rick and vnx205

    I suppose the consensus is that - it can't do any harm to lock the CDL whenever you drive on loose surfaces...

  10. #20
    Join Date
    Jan 1970
    Location
    Nanny state UK...
    Posts
    3,253
    Total Downloaded
    0
    Quote Originally Posted by isuzurover View Post
    Rick and vnx205

    I suppose the consensus is that - it can't do any harm to lock the CDL whenever you drive on loose surfaces...
    Exactly... The harm comes if you use CDL on high grip surfaces.

    M

Page 2 of 5 FirstFirst 1234 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!