Thread: Cruise control for Defender Puma 2.2

Thanks Michael, any pics of the installation?

Originally Posted by LARO

Hi All,

After much searching on Forums and talking to Landy techs
I was coming to the conclusion that it would be very difficult to get a cruise control for my MY2012 Defender Puma 2.2 without fitting some switch that should be missing to the clutch?

Aussie www.autron.com.au said they had one that would work and it does - perfectly.

Installed by Welcome to No Limit

Cheers,
Michael

Brand spanking new Puma 90 2.2 - nearly as uncomfortable as the Army one I drove in the mid 90s

Hi Michael,

I am after the same for my 2012 Defer 90.Which model did they fit I will order one and get it fitted here in Perth.
MIke

Originally Posted by Naks

Thanks Michael, any pics of the installation?

And finally I have figured how to upload a picture.

Originally Posted by Defender Mike

Hi Michael,

I am after the same for my 2012 Defer 90.Which model did they fit I will order one and get it fitted here in Perth.
MIke

The Flyby Wire model. I think they can only deliver one model that works.


Cheers,
Mcihael

I am about to fit the Autron. I contacted the company and they put me on to one of their suppliers and fitters. $880 fitted in Melbourne.

About the same in Brisbane as well. Have had it a while now and love it. Never had it drop out. only complaint would be that the controller is only held on with double sided tape and has started to sag which shows the wires. In fact if you look closely in the pic which was taken before I fixed it, you can see that the wires hole is just showing.



I took the back off and with a bit of mucking around, tapped an M3 thread into the backing and then recessed a bolt in so it doesn't interfer with the circuit board. Then I drilled the dash and have bolted it on using some double sided tape on the side to fill in the gap as the dash has a slight curve in it where mine is mounted.

See how that goes becasue it was only a matter of time before I had it dangling from the dash on a trip.

nugget,

i used 3M VHB double sided tape to attach my remote head UHF to the dash, it has not moved in 5 years. Great stuff the VHB, have loads of it in the shed.

Your dash set up looks tops, do you have any trouble with movement of the touch screen?

David

Originally Posted by nugge t

About the same in Brisbane as well. Have had it a while now and love it. Never had it drop out. only complaint would be that the controller is only held on with double sided tape and has started to sag which shows the wires. In fact if you look closely in the pic which was taken before I fixed it, you can see that the wires hole is just showing.

I took the back off and with a bit of mucking around, tapped an M3 thread into the backing and then recessed a bolt in so it doesn't interfer with the circuit board. Then I drilled the dash and have bolted it on using some double sided tape on the side to fill in the gap as the dash has a slight curve in it where mine is mounted.

See how that goes becasue it was only a matter of time before I had it dangling from the dash on a trip.

Thanks for the tip.