14th April 2012, 06:51 PM
#1
Cdl switch?
Hi all
my cdl light won't light up when I engage the cdl ?
I connected the plugs from the switch too each other and the light works.
When I jacked up one wheel and put it in neutral and pushed the leaver to lock it all worked fine.
My question is could the cdl not be engaging 100% or is the switch shot?
Any one with experience in this area ?
Cheers WMD
Attached Images
14th April 2012, 08:40 PM
#2
Sounds like the switch isn't adjusted properly or else yes, it's a gonner.
15th April 2012, 07:46 AM
#3
how is this switch adjusted?
or is it just easier to buy a new one?
cheers wmd
15th April 2012, 05:15 PM
#4
It screws into the housing and has a lock nut.
Remove the switch and see if pushing the plunger engages the light.
If so, then the switch is 100%.
To adjust.
- engage CDL
- loosen lock nut
- screw switch housing in until light comes on
- tighten lock nut
- disengage CDL and make sure light goes off
- done!
15th April 2012, 05:34 PM
#5
Thank you that's just what i needed to know.
Cheers WMD
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules
Search AULRO.com ONLY!
Search All the Web!
Bookmarks