-
11th August 2012, 04:08 AM
#1
No power from OBD !
Hi,
just got my nanocom. yesterday it works just as it should be in my pc but it seem my socket in my td5 defender has no power ! It was located out side the cabin just below the cubby box so i tried to clean it but no luck .
I also checked the fuses no 8 and no 5 ( engin box) its just fine ! . The socket has 5 wires i believe the purple should have 12 volt but mine has no power . So i tried to hot wire it from fuse no. 8 and it works but it seems it doesnt interact with ECU and it couldnt read the fault or any other !!
any advise
-
11th August 2012, 07:15 AM
#2
Does your internal light work? its on the same fuse
-
11th August 2012, 08:01 AM
#3
No problem with the lights , it works
-
11th August 2012, 08:39 AM
#4
-
11th August 2012, 11:47 AM
#5

Originally Posted by
hghareeb
Any thoghts !!
Check for Chafed loom back to the ECU then the ECU plugs and Earth points.
-
12th August 2012, 01:36 AM
#6
Well i believe the only remaining thing to do is to trace the black loom that goes out of the ECU to somewhere , the obd socket is out of this cable but it seem its very hard to trace it
and i can see no thing wrong with it from outside .
-
12th August 2012, 08:12 AM
#7
To be honest I dont really understand your post
Quote " It was located out side the cabin just below the cubby box so i tried to clean it but no luck ."
Are you saying the OBD plug has been relocated ?
Do you have a copy of RAVE with a wiring diagram?
The wiring of the diagnostic socket is not complicated so it should be relatively easy to fix
If you dont have a wiring diagram I might be able to email you one
-
13th August 2012, 01:31 AM
#8
Thank "djam1" for trying hard to understand my weak english .
yes the socket was relocated for some reason outside the cabin, i already had a look at the RAV CD accordingly i found that the purple wire in the socket should have 12vlt. power while mine has no power .
the wires should be disconnected in the middle between the fuse box and the socket !! I ended up today to hotwire it from the fuse box to the socket and try to connect my friend ( Autologic) diag. Device and see if it read or not .
thank yoy for your help.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks