Results 1 to 8 of 8

Thread: Puma Front Diff Contamination

  1. #1
    Join Date
    Jan 2008
    Location
    Goonellabah N.S.W.
    Posts
    35
    Total Downloaded
    0

    Puma Front Diff Contamination

    Hi, Gave my MY10 110 a service today at 24000km . It is it,s 2nd service having been serviced at 10000km by the dealer in Southport.
    The oil in the front diff was very dark and changed whereas the rear diff oil was clean. Is there any reason for the front diff oil to be more susceptible to contamination than that in the rear.
    Jim

  2. #2
    Join Date
    Aug 2006
    Location
    Kingston, Tassie, OZ.
    Posts
    13,728
    Total Downloaded
    0
    The CV swivel housings are filled with a Molybdenum Disulphide based grease, this will migrate to the front differential bit by bit, making the oil look dark and icky.

    It isn't a HUGE problem, but check the swivels aren't low on grease after a while.

    JC
    The Isuzu 110. Solid and as dependable as a rock, coming soon with auto box😊
    The Range Rover L322 4.4.TTDV8 ....probably won't bother with the remap..😈

  3. #3
    bencross422 Guest
    Hi Jim, This is perfectly normal if your referring to the oil being dark almost with a hint of green. This is caused by slight seepage from the inner half shaft seals which allows a very small amount of cv grease into the axle case from the swivels. Every defender from 200tdi onwards is like this, and it's nothing to concern yourself with. However it is worth annually checking the level of the cv grease in the swivels annually.
    Ben

  4. #4
    Join Date
    Jan 2013
    Location
    Alligator Creek, Queensland
    Posts
    54
    Total Downloaded
    0

    Wink

    I'm sure I read the same response twice

  5. #5
    Join Date
    May 2006
    Posts
    459
    Total Downloaded
    0
    There was another Defender 130 in my local area for a while several years ago. One place I saw it was in a garage with the swivel housings apart for replacement of the CV joints which had destroyed themselves. Think reason was lack of lubrication because grease has gone hard enough so it would not move back onto surfaces where needed after being displaced. So removed lubricant filler plugs on mine and pumped some hypoid gear oil in. Any excess presumably escaped into the diff because no leakage anywhere else. At least my CV's should now not fail because of an ill advised Land Rover measure to stop a couple of possible future oil leaks.

    Also note the Land Rover solution to oil leaking onto brakes from hubs driven by floating axles by using grease in bearings instead. Grease will only work out of and not back into the splines between the drive axles and hubs that fit over them. So splines are prone to run dry and destroy themselves. No problem with same splines running in oil on diff end of drive axles. I got as far as buying proper seals to convert my hubs from grease to oil. However, interim fix seems quite satisfactory as permanent arrangement. I just occasionally remove standard LR plastic axle caps, about half fill them with a hypoid oil / grease mixture and slap cap back on. A bit of oil/grease could probably get through grease seals onto brakes but not a continuous supply as oil seal stopping oil from diff is still in place.

  6. #6
    Join Date
    Jan 1970
    Location
    Sydney
    Posts
    1,374
    Total Downloaded
    0
    Quote Originally Posted by Disco4_tech View Post
    I'm sure I read the same response twice
    Going by the post times, I would say they were being typed at the same time.
    '51 Series 1 80"
    '12 Defender 90


  7. #7
    Join Date
    Jan 2008
    Location
    Goonellabah N.S.W.
    Posts
    35
    Total Downloaded
    0

    Puma Front Diff Contamination

    Thanks all for the replies. I have only owned the Defender 6 weeks and thought I had a major problem.Thanks to the forum I have found it is not serious.
    Jim

  8. #8
    Join Date
    Apr 2008
    Location
    Brisbane,some of the time.
    Posts
    13,886
    Total Downloaded
    0
    Watch the rear diff if you do a lot of water crossings as the breather only runs up to the rear chassis rail.

    Or better still extend it.I think the other breathers,front diff,T/C and G/B run into engine bay.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!