Thread: Traxide dual battery setup 13MY puma engine

Hi Tugga,

I installed a similar setup. Tim's USI-160, dual Optima's but used a Devon 4x4 tray which I felt was a superior tray.

Here is the link to the install. Hope it helps.

http://www.aulro.com/afvb/90-110-130...013-110-a.html

cheers,

Wayne

Thanks Wayne,

Got any tips for running the wires from the battery to the rear?

Nowhere to hide them internally so I take it you went under?

Cheers

Hi Tugga,

sorry - don't have any pictures of the cabling underneath.

However there is a significant loom that runs from near the battery box, along the passenger side chassis rail and goes up into the vehicle behind the passenger tail lights. If you look in your rear wheel arch you can see the loom with some foil/heat shield wrapped around it where it goes close to the exhaust.

I ran mine parallel to this loom (and also wrapped in foil/heat shield) and brought it up into the rear behind the tail light. Than split it to my control box and Anderson plug.

cheers,

Wayne

Thanks for the help Wayne, much appreciated

I have that exact set up. It was installed by someone else however the loom does follow the factory one to the rear like the above poster mentions.