Thread: Clutch issues? Help would be appreciated

Originally Posted by bluebike0

Pedal is on the floor and I can put it in gear while engine is running ��.

I'd be happy with that as it sounds normal so far .
Does the pedal come back if you take your foot off it? If so, does the car move?
If the pedal is stuck down, then the master cylinder is probably seized.

Might the system need flushing through....?👍🏻

Thanks Scott. No it doesn't move even in gear with engine running. Pedal is able to to pushed in but has absolutely no resistance. Hoping it may just be slave cylinder.

it may be the slave thats siezed or the throw out thats siezed.

to tell fit a blanking fitting to the flex line and try the pedal. If you can make the pedal lock up near the top then its the slave or the throw out.

it could also be the flex line collapsed and not letting the fluid come back. but that usually results in a heavy footed bugger like me bending the push rod.

you could also have a combination of issues with the throwout being stuck and a leaking/air filled slave/master cylinder.

Thanks mate, will attempt to have a look at it this weekend, fingers crossed.

Still searching for answers. Loosened slave cylinder but no joy yet. Car starts and you can select any gear you like with engine running and clutch out and it does not move, did notice front prop shaft spinning though.

😊Any LR experts in the se suburbs of Melbourne??

You don't need an expert. You have something broken in the front diff/axle if the front propshaft is moving & the car isn't.

Put the transfer case into difflock - the rear propshaft will move now, along with the car.