Thread: Rear seats 110 vs 130

Just following up on Ranga's question. I did a bit of digging and it does seem possible if you have the correct mounts.

There was also a good write up on the defender source for upgrading the low-back seats to the Puma versions:
Puma 2nd row seats in older Defender - Defender Source

Ol' mate pointed out a few good points:

1. Ensure that the chassis brackets (P/N AQR710290) are installed underneath the tub in order to bolt down the seat mounting brackets. The chassis brackets should be the same between a 110 and 130.
2. The seat mounting brackets are different between the 110 and 130 as seen from the parts list in the first image. The 110 version comes as a single piece as seen from item #2, where as the part list for the 130 is a two piece set-up.
3. From all indications, the pivot brackets in the second image have slightly different numbers but britcar and lrdirect show HTM500180 as both 110/130

Seat Diagram.jpgSeat Diagram 1.jpg