i got some sheet rubber from Clark rubber and put over the original mat.
This has removed the hole problem for a while.
Ian
Bittern
 Master
					
					
						Master
					
					
                                        
					
					
						My original floor matt is beyond a joke now. I was going to install the Exmoor mat but am struggling to justify the price and it seems hard to install.
Does anybody know if there has been an improvement in quality of the current LR offering (LR068974) or is it still paper thin?
 Master
					
					
						Supporter
					
					
						Master
					
					
						Supporteri got some sheet rubber from Clark rubber and put over the original mat.
This has removed the hole problem for a while.
Ian
Bittern
 Master
					
					
						Supporter
					
					
						Master
					
					
						SupporterI went with these to cover up the heel hole, very solid and do the job fine.
Genuine Land Rover Defender Front Floor Rubber Mats Set Part VPLDS0147 | eBay
Go home, your igloo is on fire....
2014 Chile Red L494 RRS Autobiography Supercharged
MY2016 Aintree Green Defender 130 Cab Chassis
1957 Series 1 107 ute - In pieces
1974 F250 Highboy - Very rusty project
Assorted Falcons and Jeeps.....
 Master
					
					
						Master
					
					
                                        
					
					
						I planned in getting floor mats as soon as I replaced the original
 Master
					
					
						Subscriber
					
					
						Master
					
					
						SubscriberAnyone replaced the matt that goes under and around the front seats,on the puma 110?
I can't believe how poor the quality of the original is,its just falling apart.
Anyway,been looking around,freight seems ridiculous from some suppliers.
Maybe try LR spares tomorrow?
Yes i will sit-down when they give me the price.
I replaced it with the Exmoor Trim moulded matting system as mine was disintegrating. Freight was a huge cost of it due to the weight, and i had to get help to manhandle it into position when fitting and it took a couple of goes to get it looking ok as I had to cut my own holes.
It does look much better than the original disintegrated matting.
Richard
_____________________
1985 V8 County 110
1994 TDI Discovery 1
2000 TD5 Discovery 2
2010 TDCI Defender 110
Land Rover Owners Club of Brisbane
It is useless, isn't it. I haven't bothered replacing ours, as the hard backing falls out.
If it is just to cover the seat box, you could get this
Loadspace Mat - 109/110 5door Rear Tub - Paddock Spares
Loadspace Mat - 109/110 5door Second Row - Paddock Spares
Or this is a heavier rubber and a bit more expensive from Bearmach
https://bearmach.com/rubber-mat-load...hicles-ba-2484
and cut it and stick it on. It is not heavy duty but for the price it good value. The seat box is just three sides which can be easily measured and cut i.e. two sides and a front. The piece than goes under the seats usually gets cut away to allow access to the seat boxes. I put one in the back of a 110 years ago and it is still in use. Anyway just an idea if you are stuck.
| Search AULRO.com ONLY! | Search All the Web! | 
|---|
|  |  | 
Bookmarks