Thread: 33's on my county... !!!!

Originally Posted by EchiDna

you want these:
products

i got a set through the forum, but you could import your own... NOT cheap!

cover up my 35x12.5's no problem

I think its time you posted pics of your county

Originally Posted by dobbo

No too tight,

Options

Cut and weld the bulkhead and floor

Weld some 3 inch crush tube run through the front outrigger and run it through that.

Cut off the exhaust at the front guard

Car will be at Lokka's Friday night, go have a look. Your welcome to suggest solutions.

No need to be as drastic as all that, IME there is only a slight interference (well with 285/75-16s or 255/85-16s - don't know about 33x15s on big offset rims), that can be fixed by cutting out the offending corner, and replacing it with one with 2 bends, to bring it further away from the tyre.

e.g.
|
\_

(2 bends where there was only one before).

i have an isuzu county and run 35" tyres on 15x8. misses by miles. i cant even imagine where it would hit?

can you take a picture?

Passenger side front guard, standard 31inch tyres miss the exhaust by 30mm, therefore fitting my 33's will fowl the exhaust.

mines inside the chassis rails all the way to the back. goes into the LHR wheelarch though.

Originally Posted by mitch

mines inside the chassis rails all the way to the back. goes into the LHR wheelarch though.

Any pictures from the engine bay and under the car?

Have you had to cut the bulkhead to make that fit. Not a lot of room in the engine bay for the pipe to run.

i will take some in the light tomorrow for you. mine is a turbo 4BD1 but i doubt that will make much difference.

Originally Posted by mitch

i will take some in the light tomorrow for you. mine is a turbo 4BD1 but i doubt that will make much difference.

*Cough*