Thread: Video of a cummins 6BT 110

The motor and trans in this Land Rover came from a Daf 45 roadrunner truck. It was mated to the LR Transfer case? The new 2.8LTR ISF Cummins engine is the beast to fit......
A ZF 5 or 6 speed manual gearbox will work with this engine.

Originally Posted by isuzurover

Here is another:

YouTube- 6BT 109 Land-Rover

Pretty sure this is the one owned by JP (handbuilt) from canada. It is a series landie running 38s

I want one! (but a 6BD1T would be just as good...)

Or a 6HE1TC.... yeah baby!!!

Did you ever measure up the engine bay for that 4HE1TC you had a look at on my showroom floor that day???

Andrew


Using Capitals, the difference between helping your Uncle Jack off a horse or helping your uncle jack off a horse...

hmm..... i know where theres a 6BD1T not doing anything.....

4B... $5000 full reco
Cummins 4B Engine *Reconditioned* | eBay

Buy a whole truck and rip the lot out for $6000
1987 2250D International Acco Cummins 10 Speed | eBay

or a "brand new" 6cyl for $5000
GENERATOR SET ONAN CUMMINS 6 CYL 3000 RPM | eBay

Try this video, it shows the engine in situ.

[ame=http://www.youtube.com/watch?v=O557aRSb4nA]YouTube - ‪Land Rover Cummins 6BT‬‏[/ame]


Land Rover 200 Tdi Defender owner

i'm going to build a 6bt in a defender 90

Originally Posted by LOVEMYRANGIE

Or a 6HE1TC.... yeah baby!!!

Did you ever measure up the engine bay for that 4HE1TC you had a look at on my showroom floor that day???

Andrew

I posted the measurements on here. It would fit. Slightly taller, but should be OK with a puma bonnet. The biggest issue is the starter is on the gearbox side on those engines, so some serious tunnel mods would be needed to run an isuzu box, or serious engine bellhousing mods to turn the starter around.

They would be a perfect option for a forward control landie though!

The exhaust is also on the driver's side, but that is less of an issue, as the 4JB1 is the same and they go in OK.