Defender axle circlips

**Xtreme** · 1st February 2010, 08:30 PM

Originally Posted by JDNSW

Code:

The most likely point of failure is not the bit that is bent over, but the tab that fits in the keyway, and you have to be very certain that it is undamaged and still a good fit in the keyway.

John

Good point John.
Also, the later lockwashers & stubaxles - not sure when they changed - utilised a flat section instead of the keyway and were therefore less prone to damage in that area.

**Fraz** · 1st February 2010, 11:06 PM

Thanks guys, As it turns out, I spoke with the mechanic that did the work, and he said there was 'no circlip on the old axles', which leads one to wonder why he did not inform anyone that there were none on the now new ones, considering he knew they needed to be there.

Aside from that, It seems that the flanges and hubs were removed for the locker install, and were never re-torqued properly.. They have simply failed from too much play.

Good news though, management were very understanding and agreed to replace the gear, but I will be installing it as its on axle stands in my garage right now. All goes to show that if you keep your cool and smile, things can work out

The bad news is that BMI only have one stub axle, so I have to wait till friday at the earliest

But you cant have everything hey...

Cheers again
Fraz

**Fraz** · 1st February 2010, 11:09 PM

forgot to mention, The lockers are great

There was one issue with an o-ring on the front but unrelated to this post.

And, The nut is the single one that you smash the side into the key.

Thread: Defender axle circlips

Thread Tools

Bookmarks

Bookmarks

Posting Permissions