Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 26

Thread: Has anyone tried a Steinbauer chip in their Puma?

  1. #11
    Join Date
    Oct 2007
    Posts
    370
    Total Downloaded
    0

    Has anyone tried a Steinbauer chip in their Puma?

    Well, I tried a Steinbauer, after reading a lot of good reports about them, but unfortunately it made no difference to my ’07 Puma. I have no doubt that they have a lot of success with them as I know people who have them, but no benefit on mine.

    I don’t know if it is a Puma engine management over ride thing or something else, but the diesel shop guys, who supplied it, said it was right by their lap top. They later dyno’d it and acknowledged it wasn’t working, replaced the unit, and even had the Steinbauer tech gurus from Austria work on it during a visit to Australia. They also claimed it was working well (by their laptop).

    After persevering for 3 months I asked for a refund, and bought a Tunit which worked brilliantly! Doesn’t need a technician to fit, and easily adjusted to the required power needs. In fact, it was critical in giving me enough power to blast over the Simpson dunes last year. I just turned it up to notch 6 for that. I think it goes from 1 to 10, but I haven’t set it past 6 as yet. It is also very compact. The Steinbauer is quite bulky for a high tech chip!

    Just wondering if anyone has used a Steinbauer successfully on their Puma?

    Brid

  2. #12
    Join Date
    Jan 1970
    Location
    Down the road from Sydney
    Posts
    14,702
    Total Downloaded
    0
    there is no way I would chip my defender while in warranty........
    Our Land Rover does not leak oil! it just marks its territory.......




  3. #13
    Join Date
    Oct 2007
    Posts
    370
    Total Downloaded
    0
    Fair enough comment I suppose, but 100,000kms is a long time to be deprived of some much improved driveability!

    For me, I'll take the chance & it can be removed in 5 mins if needed.

  4. #14
    Join Date
    Apr 2009
    Location
    Karalee Qld
    Posts
    333
    Total Downloaded
    0
    Quote Originally Posted by dullbird View Post
    there is no way I would chip my defender while in warranty........

    I am the same Dullbird - but would you chip it out or warranty?

  5. #15
    Join Date
    Jan 1970
    Location
    Down the road from Sydney
    Posts
    14,702
    Total Downloaded
    0
    Quote Originally Posted by SVX37 View Post
    I am the same Dullbird - but would you chip it out or warranty?
    good question..no I wouldn't I do not see the need the car has plenty of usable power....the car gets up to 130 very quickly so I see no need for the extra speed..

    we pulled almost 3 ton with the car the other day and it pulled it like it wasn't there! so happy with the usable torque as well

    this is just my own experience of course
    Our Land Rover does not leak oil! it just marks its territory.......




  6. #16
    Join Date
    May 2007
    Location
    Safety Bay
    Posts
    8,041
    Total Downloaded
    0
    I'm with dullbird on this,around here chips and mandrel exhaust are very common,so are driveline failures and dealers are wiseing up to warranty claims.Subaru paint mark their covers and chip retaining screws and if there is the slightest mark on the paint warranty is void. Pat

  7. #17
    p38arover's Avatar
    p38arover is offline Major part of the heart and soul of AULRO.com
    Administrator
    I'm here to help you!
    Gold Subscriber
    Join Date
    Jan 1970
    Location
    Western Sydney
    Posts
    30,704
    Total Downloaded
    1.63 MB
    It has been mentioned on here. A search will find it.

    Oh, it was you. http://www.aulro.com/afvb/90-110-130...ma-engine.html

    I'll merge the threads.
    Ron B.
    VK2OTC

    2003 L322 Range Rover Vogue 4.4 V8 Auto
    2007 Yamaha XJR1300
    Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA



    RIP Bucko - Riding on Forever

  8. #18
    Join Date
    Dec 2006
    Location
    Qld.
    Posts
    5,901
    Total Downloaded
    0
    Quote Originally Posted by Brid View Post
    Well, I tried a Steinbauer.......Doesn’t need a technician to fit, and easily adjusted to the required power needs. In fact, it was critical in giving me enough power to blast over the Simpson dunes last year.

    Brid
    What route did you take over the Simpson?
    2007 Defender 110
    2017 Mercedes Benz C Class. Cabriolet
    1993 BMW R100LT
    2024 Triumph Bonneville T120 Black

  9. #19
    Join Date
    Oct 2007
    Posts
    370
    Total Downloaded
    0
    Hi

    We left from Birdsville via Big Red to Eyre Creek going about 20km north through Annandale Station to cross, then back track down again to re-connect on the QAA line to NT border. South on K1 Line past Poeppel Cnr to turn west on the Rig Road. Did a clockwise loop going north to join the French Line, then heading east to re-track on the QAA & Big Red again.

    We were one of 51 vehicles in 4 groups doing the Drive4Life charity run. I can’t resist giving a huge plug for Drive4Life. They raise money for wheel chairs for disabled and every cent goes to Northcott Society for this purpose. Each vehicle donates $1000 to join an extremely well organized trip, with all the best back up support (sat phones, break down support, even organizing parts) to travel remote areas safely.

    Here is the link Drive 4 Life - Fundraising 4WD Tours |Victorian High Country|Simpson Desert

    That’s our 3rd trip with them, and we always end up making more great friends. So, if you want to join us on the next one (Flinders Ranges in October), check the website out.

    Regards
    Brid

  10. #20
    Join Date
    Oct 2007
    Posts
    370
    Total Downloaded
    0
    Quote Originally Posted by PAT303 View Post
    I'm with dullbird on this,around here chips and mandrel exhaust are very common,so are driveline failures and dealers are wiseing up to warranty claims.Subaru paint mark their covers and chip retaining screws and if there is the slightest mark on the paint warranty is void. Pat
    Just bear in mind that there is often a lot of bluff in dealer warranty statements. I am involved in supplying a product for engines to the mining industry, and can tell you there is never any support for aftermarket product by manufacturers. However, their warranty must cover materials and workmanship. If their is a problem with the engine, their warranty covers it.

    If it can be shown that the aftermarket product, additive or whatever, caused a failure or problem, they have no responsibility to repair or rectify.

    OEM's & dealers will often try to get out of warranty by pointing to another product causing it, and you might have a battle, but if you know how you stand legally (and the product has not caused damage) the law is on your side.

    I dealt with one mine that was told their warranty would be voided unless they used the engine manufacturers brand oil, while a BHP group of mines all used the recommended oil specification in a Mobil brand...knowing that there were no warranty problems at all. (This is unrelated to my business...just an example I came across.)

    In my case, I don't believe the Tunit will cause any damage, and there are no reports I am aware of that indicate problems. Also, I don't drive it hard so there is only a small risk, and I am happy to use it under warranty, and enjoy the better drive.

    Regards
    Brid

Page 2 of 3 FirstFirst 123 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!