Reply With QuoteWhat engine? The dizzys are different between the 3.5 and the 3.9's. it shouldn't be too hard to find a replacement dizzy from someone here.
Master
Hello
So working on my engine last week and had a little accident and broke the vacuum advance unit of the dizzy. When I inspected it the screws had a small bit of metal around them so I'm guessing it's taken the metal with it. My first thought was a new dizzy or bigger screws.
Can anyone help.
Super Moderator & CA manager
SubscriberWhat engine? The dizzys are different between the 3.5 and the 3.9's. it shouldn't be too hard to find a replacement dizzy from someone here.
If you need to contact me please email homestarrunnerau@gmail.com - thanks - Gav.
Master
Try a thicker but not longer screw. Was it even working ?, a lot of the older ones have stopped working and if that's the case you wont notice any difference without it. so long as the mechanical advance is working then I wouldn't be to worried about it.
Master
Ok when it was on it ran well and idled but now it's off it's a bit rough and won't idle
Master
It's a 3.9 efi
Master
Have you blocked off the hose now that its offOriginally Posted by disco dan
Master
suck on the fitting and see if the rod pulls in and hold the vacuum with your tongue and see if the rod holds/stays in.
Master
Haven't blocked it but will try it. When I suck on it it comes in a little but doesn't hold when I put my tongue over it.
Master
so it was / is faulty, so you shouldn't notice any different without it
Master
There was a difference when it was on. It's on gas also and ran fine on gas. Now I have got it running on fuel again as injectors where screwed
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks