Thread: RFSV Dickie Seat Removal

Originally Posted by wpalmo

I ended up removing the seat out from the beams. It took a bit to work out the system but it was the only way I could get the seat out. Good luck!
Regards Warrick.

Cheers


I couldn't get to the bolts under the seat base until I'd removed the beams. Now the issue I have is the bolts that go up into the seat base [front] just spin but aren't undoing. I've tried to remove the seat base but only found a single allen bolt up towards the back and removing it did nothing


REALLY don't want to stuff things as although the seat isn't required now I'd like to be able to put things back to "Mil Spec" as required.




Thanks again

Originally Posted by 87County

Probably alot easier after one or both side bins and inside jerry csn holders are removed - in itself that can be tedious. Removing the seat from the rails usually requires holding the bolt within the seat to stop itspinning.

I ended up using a rattle gun to undo those nuts. It worked well and I didn't need to hold the bolt head. Hopefully my dickie seat removal wasn't just a fluke and it works for other too!
Regards Warrick.