Thread: Injectors

Most likely they would have had the rubber seal when fitted but over time it does perish and probably with the number of times they would have been cleaned with a gurney has contributed to them falling apart. They are not much of a seal really. I coat the injector body with neversieze and also smear it around in the recess in the head when I change them. Must have been really corroded into the head for the injector to break. There are second hand injectors in this month's AFM auction but just check the part number as most of the ones I have seen auctioned so far have been turbo motor injectors.

Hi Guys,
I was wondering about this aspect...going forward.
Does one buy auction injectors ??? or get your original ones serviced.
At present (with no information or experience) i am thinking serviced to be a better outcome than an unknown entity.
W

My injectors ( 1 of which was torn in half) were fitted with new tips which cost $360 ,cleaned tested , supplied with new copper washers and rubber top water seal , cost $600 from B and M INJECTION Auburn N S W .

My injectors ( 1 of which was torn in half) were fitted with new tips which cost $360 ,cleaned tested , supplied with new copper washers and rubber top water seal , cost $600  from B and M INJECTION Auburn N S W .