Passing through briefly and will try to answer the questions I have seen pop up.
The unit comes with Synergic (?) GPS software. The one I had previously had iGO 8 on it. Both work well and both have their nuances.
As far as mounting and the screen opening fully, you can't push the cradle fully back since this causes the lip on the dashboard to interfere with the 'arms' that make up part of the display angle adjustment. If you set the cradle about 5mm proud of the dash, everything works fine.
Unit only has a single camera input.
As mentioned previously, OZI works fine. The unit can be thought of as an 'unlocked' WinCE based GPS with removable SD card. I have iGO and OZI installed on the same SD card. To switch between them I just go into the settings and change where the GPS expects to find its software. Then reboot the GPS. All up takes about 45 seconds to do the config change plus however long the software takes to boot. I don't recommend doing the change on the move though since it requires accurate fingers.


Reply With Quote
.


Bookmarks