Page 2 of 4 FirstFirst 1234 LastLast
Results 11 to 20 of 31

Thread: Problems powering notepad with UPS in cabin

  1. #11
    Join Date
    Oct 2010
    Location
    Dixons Creek Victoria
    Posts
    1,533
    Total Downloaded
    0
    Quote Originally Posted by fraser130 View Post
    Wagoo, what are you charging the big batteries with?
    If it is a 240v charger, leave the genny miles away, and run the 240 to the charger which is next to the batteries, which can be right next to the shed, you will get almost no voltage drop over even 60m of good quality extension leads if you are only powering a 240v -12v charger for your batteries.....just a thought

    Fraser
    Fraser, I have a 65 AH Bosch alternator driven by an 8hp petrol engine.Actually the alternator is fitted to my walk behind grass slasher. How far could I park that away from the batteries?
    I charge and use the batteries in individual pairs, and I have 8 pairs in total.
    I've tried connecting all the batteries together as one large 12 volt bank, but it kills alternators and loads the engine for too long when it comes time to recharge.
    Bill.

  2. #12
    Join Date
    May 2006
    Location
    Carlton, Melbourne
    Posts
    1,115
    Total Downloaded
    0
    In all honesty Bill, I would go for a small 240v Genset running a "smart" charger, and have all the batteries connected as one bank, batteries are expensive, and I wouldn't risk them with just a car alternator doing the charging, or mucking about with swapping pairs about.

    But to answer your last question, not far, and you will have even higher current through the cable from the alternator, so it will not get an accurate "feeling" for the voltage of the batteries.

    If I have read your first posts correctly you have 8 pairs of 150Ah batteries, so thats a total of 1200Ah at 12v, so if you have them all connected together as a 12v bank, you are safe to pump 120A into them for at least 10 hours if they were flat!
    That's a hell of a lot of current and stored power.

    There are some good inverter/charger combined units about at the moment that can charge at 50A, and you would be looking at least 24 hours of straight running to charge the batteries from flat.

    Now, a 50A charge at 12v would require a 600w genset (in reality you would want around 1Kva)
    at 120A you need 1.4Kw (again probably a 2Kva genset, but you would be hard-pressed to find a 120A 12v charger)

    Now as I'm sure you know it's not good practice to use more than the top 10% of charge if you want the batteries to last, so we are looking at 120Ah, so a 50A charger would replace that in only 2.4 hours.
    If you had a 25A charger (300w at 12v), it would take 5 hours to charge that 10% and it could be run by a very small genset (a 500W one would do).... (in reality it is longer, but you get the idea..) all of this would allow the genny to be a long way away, and not suffer from voltage drop....

    I hope some of that helps.......

    Cheers,
    Fraser

  3. #13
    Join Date
    Oct 2010
    Location
    Dixons Creek Victoria
    Posts
    1,533
    Total Downloaded
    0
    Thanks very much Fraser, that is all very helpful information.
    To be honest, I didn't know that 240/12volt battery chargers were available in such high ratings.
    Bill.

  4. #14
    Join Date
    May 2006
    Location
    Carlton, Melbourne
    Posts
    1,115
    Total Downloaded
    0
    Quote Originally Posted by wagoo View Post
    Thanks very much Fraser, that is all very helpful information.
    To be honest, I didn't know that 240/12volt battery chargers were available in such high ratings.
    Bill.
    Bill, I have one of these and it's excellent, very efficient too.
    I have since noticed these too.... there are others about too...

  5. #15
    Join Date
    May 2006
    Location
    Carlton, Melbourne
    Posts
    1,115
    Total Downloaded
    0
    Just for interest Bill, where did you get your batteries from?
    I have a mate who is setting up a shed on his new property to live in, and I'm the guy who's doing it for him......

    Cheers,

    Fraser

  6. #16
    Join Date
    Oct 2010
    Location
    Dixons Creek Victoria
    Posts
    1,533
    Total Downloaded
    0
    Quote Originally Posted by fraser130 View Post
    Just for interest Bill, where did you get your batteries from?
    I have a mate who is setting up a shed on his new property to live in, and I'm the guy who's doing it for him......

    Cheers,

    Fraser
    Fraser.
    The batteries were given to me by a mate and neighbor who used to work for Telecom, who replace batteries on a schedule rather than as needed basis.
    My collection is probably getting a bit long in the tooth, and I've been charging them as a single 12 volt bank for the past 2 years with an 80 ah alternator fitted to an additional belt pulley on my 6kva gen set powered by a larger 18 hp petrol engine.The engine failed about 4 weeks ago, and I figured I had more power than was required for battery charging, and the 6kva wasn't really sufficient for welding,(I have a larger genset for those tasks), Hence the fitting of the 65 amp alternator to my 8hp grass slasher.

    I'm a little concerned at the amount of power the DC/DC convertor uses.
    I made a 4metre long, heavy cable and placed a partially charged {11.6 volt} 12 volt 100Ah deep cyle battery close to the cabin as a trial.
    With the PC battery removed and only the Modem and DC convertor connected to the 12 volt battery I only get 2 hours of operation before the PC shuts down due to insufficient power.Unconnected the battery reads 10.03 volts 4 hours after shutdown.
    The whole purpose of trying to run everything on 12 volts was so that I could lose the power hungry 1000 watt invertor that i've been using to power everything for the past 2 years, that was costing me a jerry can of fuel a week to keep the battery bank topped up sufficiently to prevent the invertor fom shutting down. So far, and due only to the computer it appears that I'm no better off.
    i've just connected up the small 370 cca battery out of my wifes Honda, which currently reads 13 volts when connected.I'll see how long til shutdown.
    Bill.

  7. #17
    Join Date
    May 2006
    Location
    Carlton, Melbourne
    Posts
    1,115
    Total Downloaded
    0
    Bill, 11.6 Volts is a flat battery!
    Just for interest, is the laptop adapter getting hot? If it's not, then it's working efficiently, as any power it actually uses is given off as heat.
    I've attached a little file showing what voltage equals how much charge.....

    What brand/model number is your adapter? Mine is fantastic, and barely gets warm during use.




    If ever you can get any more batteries, be sure to let me know!!

    Cheers,
    Fraser
    Attached Images Attached Images

  8. #18
    Join Date
    Oct 2010
    Location
    Dixons Creek Victoria
    Posts
    1,533
    Total Downloaded
    0
    Thanks for the chart Fraser. That is very interesting and I'm very surprised that the % of charge drops so dramatically with barely 1 volt difference between full and flat.
    I have 2 brands of DC adaptors. a Power Tech Plus mp3463 one and a Ritmo brand KC195 digital output voltage readout type one.The Power Tech one that has been on for about 5 hours is still room temperature. I haven't tried the other one for more than 2 hours but don't think it got hot. I'll try it later once i know how long the Honda battery lasts until shutdown.
    I'll certainly let you know if anymore batteries become available. Somebody told me that it's worth checking with golf courses, as they replace buggy batteries at scheduled periods.I haven't personally done so.
    Where is your friends property? I am in the hills of Dixons Creek.
    Bill.

  9. #19
    Join Date
    Jan 1970
    Location
    2780
    Posts
    8,257
    Total Downloaded
    0
    That Ritmo one looks like it's got enough zzz's to power anything.

    https://secure.vividcluster.crox.net...3&form=KEYWORD

    Ritmo Online

    How's the cigarette adapter? Maybe losing some at that connection?

  10. #20
    Join Date
    Oct 2010
    Location
    Dixons Creek Victoria
    Posts
    1,533
    Total Downloaded
    0
    Quote Originally Posted by abaddonxi View Post
    That Ritmo one looks like it's got enough zzz's to power anything.

    https://secure.vividcluster.crox.net...3&form=KEYWORD

    Ritmo Online

    How's the cigarette adapter? Maybe losing some at that connection?
    Good secure contact and good quality double socket with heavy wire.
    This has been an education for me.Aside from battery voltage readings, which are a bit misleading when the battery has just come off the charger, i'd always assumed that if the engine RPM on my ungoverned engine didn't increase when I disconnect the battery from the alternator, then that was all the charge that the battery would accept. It would appear that until I can afford a decent size 240/12 volt battery charger and good quality 1 kw genny, that I will need to charge individual battery pairs in stages with around a 45 minute break each time, as that seems to be the time lapse before I get an accurate voltage reading.
    Bill.

Page 2 of 4 FirstFirst 1234 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!