Thread: rear tail shaft 95 disco

hi folks just like to no if anyone has changed there rear tail shaft for a range rover one i have a rear 93 range rover drive shaft but i see the yolk is different on the disco do i have to change diff center ? or can i just leave the standard drive shaft on, its a two inch lift i'm putting on or can i use the yoke out of the range rover diff, its just the rubber on the disco drive shaft i'm worried about,and how do you get the yoke of the disco must be a trick to it thanks Luke.

I did the exact same jod recently with a shaft from my old 86 Rangie.I used a flange from the front diff from the Rangie which was from a 97 Disco.As pointed out by Wongdai make sure you don't forget the spacer before the flange goes on,the spacer is about 12mm thick and without it you will get a heap of backlash.Removing the Disco flange was a bugger of a job because a centering bush with a threaded centre has to be removed to access the pinion nut and I had to gently cut the flange apart with a grinder due to a pulley not working because it was so tight as they are fitted with loctite.A good slide hammer could be a worth a try also.Good luck.
Cheers
Shane