Results 1 to 4 of 4

Thread: Starting problems

  1. #1
    Join Date
    Aug 2011
    Location
    Strathalbyn SA
    Posts
    53
    Total Downloaded
    0

    Starting problems

    Beautiful sunny morning here.... Until I went out and tried to start the Disco 300tdi.

    Turned the key, lights came on but when I tried to start ... nothing.
    Happened before so swapped batteries and it's been fine for two weeks. Previously when it happened the battery power was down to about 12v so the change of battery seemed to solve the problem.

    This morning I tested the batteries and the meter was reading 17v! When I finally started the car after rocking it forward and back while in gear I tested again and the reading was around 19v!

    Any thoughts?

  2. #2
    Join Date
    Mar 2011
    Location
    South Aust
    Posts
    249
    Total Downloaded
    0
    Voltage regulator or Volt meter faulty?

    Dave

  3. #3
    Join Date
    Aug 2011
    Location
    Strathalbyn SA
    Posts
    53
    Total Downloaded
    0
    Think the tester is dodgy. Tested a battery from a torch and it read high.

  4. #4
    Join Date
    Mar 2011
    Location
    Cooktown, North Queensland
    Posts
    236
    Total Downloaded
    0

    Wink Start solenoid supply.

    Sounds a lot like a "dry joint" on the spade connector that connects the start supply wire from the key where the wire connects onto the starter solenoid, it can cause some puzzling starting problems. I cut the old one off and crimped on a new connector and have had no mysterious no-go's since.
    As far as the volts go, if the values you are reading are correct, (as you say it seems not), then your alternator regulator may be faulty, but more volts will not stop the starting process.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!