-
7th July 2014, 08:18 PM
#1
Cruise control Fix
Well after replacing a lot of bits I probably didn't need to I finally fixed my cruise control today. The main problem was (apart from perished vac lines) the clutch vac switch wasn't contacting the clutch pedal causing the system to think the clutch was depressed all the time. So after slotting in a loose nut with some airframe tape onto the pedal to close the switch it works, it finally works.
-
8th July 2014, 06:45 AM
#2
Well done! mine stopped working too but it was just a split hose on vac pump.
-
8th July 2014, 10:14 PM
#3
Are did you know the switch is on a ratchet? in other words, if you pull on the plunger gently you can extend it that bit further so it takes up the gap. That's how you adjust the vacuum switch 
Regards, Mario
-
9th July 2014, 07:33 AM
#4
No I didnt know that. Oh well when the nut falls off i might have a look at it again haha
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks