Thread: D1 rear reverse/work light options?

Originally Posted by Corgie Carrier

Hi Dave

Nice simple set up. Rear bar looks good

How did you run the wires to the inside?

Hi Neale,
I hope your treating my rear end well.....


I ran the power wire in to the door by drilling a hole behind the wheel holder and put a rubber grommet to protect it. Then I fed the wire into the car by pushing through the rubber tube the car wires go through. I put a laminating switch on the dash so I could see if it was on or not. I did not worry about using relays to switch because I was using low current LED inserts, just fused it to protect the wiring.

Originally Posted by Look

i just mounted mine in my spare wheel (there is a waterproof plug so i can unplug it if i need to remove the spare wheel) was simple and took 10mins to make and works well

I was thinking that, but currently runs a cover.
Few options here, will have to dummy up a few and see what works.