Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: 4HP24E into Disco 1 V8

  1. 2nd March 2016, 02:42 PM #11
    DiscoClax's Avatar
    DiscoClax
    DiscoClax is offline Master Silver Subscriber
    Join Date
    Mar 2008
    Location
    Kilmore, VIC
    Posts
    848
    Total Downloaded
    106.38 MB

    Pictures !!! - part 1

    OK, so "a few days" turned into "a few weeks" but belatedly here are some pictures...

    Testing the trans next to the car to ensure the controller was talking to it correctly. Plus a gratuitous shot of the back of the engine with the P38A early flexplate and one of the controller hooked up and displaying the 'combined info' screen.
    Attached Images Attached Images
    DiscoClax
    '94 D1 3dr Aegean Blue - 300ci stroker RV8, 4HP24 & Compushift, usual bar-work, various APT gear, 235/85 M/Ts, 3deg arms, Detroit lockers, $$$$, etc.
    '08 RRS TDV8 Rimini Red - 285/60R18 Falken AT3Ws, Rock slider-steps, APT full under-protection, Mitch Hitch, Tradesman rack, Traxide DBS, Gap IID
    Reply With Quote Reply With Quote
  2. 2nd March 2016, 02:44 PM #12
    DiscoClax's Avatar
    DiscoClax
    DiscoClax is offline Master Silver Subscriber
    Join Date
    Mar 2008
    Location
    Kilmore, VIC
    Posts
    848
    Total Downloaded
    106.38 MB

    Pictures !!! - part 2

    Pictures of the transfer case mounts after modifying to allow them to move rearwards along the chassis by 15mm...
    Attached Images Attached Images
    DiscoClax
    '94 D1 3dr Aegean Blue - 300ci stroker RV8, 4HP24 & Compushift, usual bar-work, various APT gear, 235/85 M/Ts, 3deg arms, Detroit lockers, $$$$, etc.
    '08 RRS TDV8 Rimini Red - 285/60R18 Falken AT3Ws, Rock slider-steps, APT full under-protection, Mitch Hitch, Tradesman rack, Traxide DBS, Gap IID
    Reply With Quote Reply With Quote
  3. 2nd March 2016, 02:46 PM #13
    DiscoClax's Avatar
    DiscoClax
    DiscoClax is offline Master Silver Subscriber
    Join Date
    Mar 2008
    Location
    Kilmore, VIC
    Posts
    848
    Total Downloaded
    106.38 MB

    Pictures !!! - part 3

    Showing the effects of the 15mm thicker pump housing. The pencil brace required cutting and lengthening and the dipstick tube bracket (re-used from the original 4HP22H) required reprofiling (bending).
    Attached Images Attached Images
    DiscoClax
    '94 D1 3dr Aegean Blue - 300ci stroker RV8, 4HP24 & Compushift, usual bar-work, various APT gear, 235/85 M/Ts, 3deg arms, Detroit lockers, $$$$, etc.
    '08 RRS TDV8 Rimini Red - 285/60R18 Falken AT3Ws, Rock slider-steps, APT full under-protection, Mitch Hitch, Tradesman rack, Traxide DBS, Gap IID
    Reply With Quote Reply With Quote
  4. 2nd March 2016, 02:51 PM #14
    DiscoClax's Avatar
    DiscoClax
    DiscoClax is offline Master Silver Subscriber
    Join Date
    Mar 2008
    Location
    Kilmore, VIC
    Posts
    848
    Total Downloaded
    106.38 MB

    Pictures !!! - part 4

    Final installment... Pictures of trimming the length of the output shaft, chamfering, drilling and tapping. Plus one of the LT230 intermediate shaft slipped home (but not bolted up).

    The back of the trans was stuffed full of clean rags, taped up, and then a cardboard box was slipped over the shaft and taped around the spline. The bearing collar from the 4HP24 was used as a cutting guide (worm band clamp behind it) and the cutting was done slowly, working around the shaft, to minimise annealing effects.
    Attached Images Attached Images
    DiscoClax
    '94 D1 3dr Aegean Blue - 300ci stroker RV8, 4HP24 & Compushift, usual bar-work, various APT gear, 235/85 M/Ts, 3deg arms, Detroit lockers, $$$$, etc.
    '08 RRS TDV8 Rimini Red - 285/60R18 Falken AT3Ws, Rock slider-steps, APT full under-protection, Mitch Hitch, Tradesman rack, Traxide DBS, Gap IID
    Reply With Quote Reply With Quote
  5. 2nd March 2016, 04:21 PM #15
    loanrangie's Avatar
    loanrangie
    loanrangie is offline LordRover Subscriber
    Join Date
    Jan 1970
    Location
    St Helena,Melbourne
    Posts
    16,778
    Total Downloaded
    1.13 MB
    Love the hi-tech shield .
    MY08 TDV6 SE D3- permagrin ooh yeah
    2004 Jayco Freedom tin tent
    1998 Triumph Daytona T595
    1974 VW Kombi bus
    1958 Holden FC special sedan
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Dicovery 1 front end a question or two | Back on the road »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!