Results 1 to 9 of 9

Thread: Electric seat fuse rating

  1. #1
    Discobaker Guest

    Electric seat fuse rating

    G'day guys, the fuse for the drivers elec seat keeps blowing? It's got a 30amp fuse in it & I'm hesitant to put in anything higher in case it blows something else. I'm unsure what rating it's supposed to be as I've so far just put in what I've taken out being the 30amp fuse. It'll last maybe a month before it pops & adjustment of the front seat is almost non existent. Any suggestions greatly appreciated, should it be a higher rated fuse or should I be looking elsewhere?
    Tia
    Mat

  2. #2
    Join Date
    Feb 2009
    Location
    Newborough, VIC
    Posts
    1,540
    Total Downloaded
    67.72 MB
    Hi Mat,
    Unless you know for sure that the fuse is smaller than specified, DON'T put in a bigger fuse. The last thing you want to do is burn out your motor.
    If there is a problem, it is not with the fuse.
    More likely, the wiring is shorting to earth, or your seat motor is pulling too many amps. If it's the latter, you need to find out why it is overloading. A bent or siezed linkage/coupling/bearing perhaps.
    Cheers,
    biggin
    2002 D2 4.6L V8 Auto SLS+2" ACE CDL Truetrac(F) Nanocom(V8 only)

  3. #3
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    Quote Originally Posted by Discobaker View Post
    G'day guys, the fuse for the drivers elec seat keeps blowing? It's got a 30amp fuse in it & I'm hesitant to put in anything higher in case it blows something else. I'm unsure what rating it's supposed to be as I've so far just put in what I've taken out being the 30amp fuse. It'll last maybe a month before it pops & adjustment of the front seat is almost non existent. Any suggestions greatly appreciated, should it be a higher rated fuse or should I be looking elsewhere?
    Tia
    Mat
    Replace the fuse with a similar rated thermal circuit breaker. Used in electric window systems, and should be findable from wreckers or a decent sparkie perhaps.

  4. #4
    Discobaker Guest
    Cheers guys, I'll get onto it when I get into the prop shaft boot & tie rod ends

  5. #5
    Join Date
    Jan 2008
    Location
    Grange, Adelaide
    Posts
    699
    Total Downloaded
    0
    Seat Electrics should be a 40 amp fuse (orange)
    Next to it are two 3 amp (violet) fuses for the Lumbar Support Pump and Lumbar Pump Solenoid.

    They are located under each of the front seats.

  6. #6
    Discobaker Guest
    Quote Originally Posted by simonl8353 View Post
    Seat Electrics should be a 40 amp fuse (orange)
    Next to it are two 3 amp (violet) fuses for the Lumbar Support Pump and Lumbar Pump Solenoid.

    They are located under each of the front seats.
    Awesome, so maybe it was just too lower rated fuse. Thanks heaps Simon. Much appreciated

  7. #7
    Join Date
    Feb 2009
    Location
    Newborough, VIC
    Posts
    1,540
    Total Downloaded
    67.72 MB
    Quote Originally Posted by simonl8353 View Post
    Seat Electrics should be a 40 amp fuse (orange)
    Next to it are two 3 amp (violet) fuses for the Lumbar Support Pump and Lumbar Pump Solenoid.

    They are located under each of the front seats.
    Spot on Simon,
    RAVE says same thing.
    2002 D2 4.6L V8 Auto SLS+2" ACE CDL Truetrac(F) Nanocom(V8 only)

  8. #8
    Join Date
    Apr 2008
    Location
    Adelaide SA
    Posts
    2,517
    Total Downloaded
    0
    With electrics blowing fuses, it is best to be safe now than sorry later.

    I would suggest that you remove the electric seats altogether. As a service, I will take them off your hands for you, and even give you some replacement manual seats.


  9. #9
    Discobaker Guest
    Thanks Bas but I'll take my chances, you can have em if I blow em up though

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!