Reply With Quotecan't remember if its top and bottom, or either side, cut a couple of pieces of plastic the size of a credit card from an icecream container lid, and slide in. This will release a couple of clips and the whole assembly should pop out.
Master
clock removal
hopefully an easy one. need to pull the clock out of the discovery to replace blown globe. is the clock and door switch bolted in or does it lever out. same issue with the radio and temperature adjustment control if anyone has done these as well.
Fossicker
Subscribercan't remember if its top and bottom, or either side, cut a couple of pieces of plastic the size of a credit card from an icecream container lid, and slide in. This will release a couple of clips and the whole assembly should pop out.
Master
Supporterit's not bolted, believe you can slip a thin metal strip each side to release the catches e.g. steel ruler and it pulls out. multiplugs on the rear of the clock and door switch
_________________________
1996 D1 V8 - gone
2002 D2 Td5 ES- gone but still running elsewhere
2013 D4 SDV6 HSE - gone
2023 Defender 110SE D300
Master
Try this
http://www.aulro.com/afvb/discovery-...placement.html
Dazza
ChatterBox
SupporterAs above for he clock, try sides or top and bottom, can't remember which it was.
As for the Temp/Aircon, remove the ashtry and coin tray (you need to remove the cup holders as well) then reach in with your fingers and push in the clips, the entire unit slides out, easy job
D4 SDV6, a blank canvas
OK, all fixed now - Thanks heaps.
Found the four retaining clips that allowed the easy release and it just popped out with a dull screwdriver.
Many thanks to all,
Shirley..
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks