Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 22

Thread: Alpine HK stereo "no cd"

  1. #11
    Join Date
    May 2003
    Location
    On The Road
    Posts
    30,031
    Total Downloaded
    0
    so you get sound from the radio but not the new saucy USB stick?
    "How long since you've visited The Good Oil?"

    '93 V8 Rossi
    '97 to '07. sold.
    '01 V8 D2
    '06 to 10. written off.
    '03 4.6 V8 HSE D2a with Tornado ECM
    '10 to '21
    '16.5 RRS SDV8
    '21 to Infinity and Beyond!


    1988 Isuzu Bus. V10 15L NA Diesel
    Home is where you park it..

    [IMG][/IMG]

  2. #12
    mattg Guest
    Quote Originally Posted by Pedro_The_Swift View Post
    so you get sound from the radio but not the new saucy USB stick?
    No other audio sauce works. I have tried front and rear USB input as well as 3.5 mm aux input with the iPhone. Both input are recognized I can even control the iPhone audio from the JVC but no sound comes out. I might post in the electronics section and see if a Techy there can help. Good radio audio when solid signal available

    Cheers MG

  3. #13
    mattg Guest
    Well I connected a 2 RCA out pioneer HU tonight and got no audio from any source.

    Do I need to connect the remote turn on wire to something? I don't think I do as the radio comes through fine. I'm getting very frustrated.
    Any ideas?

  4. #14
    Join Date
    Jul 2010
    Location
    Hunter Valley NSW
    Posts
    750
    Total Downloaded
    0
    Are you sure you have an 11 speaker HK system? An amplifier under the front passenger seat?
    Subwoofers on tail gate?
    Regards

  5. #15
    mattg Guest
    Yep and mids have Harmon Kardon on them and on stickers on the magnets. And subs on tailgate

  6. #16
    Join Date
    Oct 2013
    Location
    Wodonga
    Posts
    88
    Total Downloaded
    0
    Quote Originally Posted by mattg View Post
    Well I connected a 2 RCA out pioneer HU tonight and got no audio from any source.

    Do I need to connect the remote turn on wire to something? I don't think I do as the radio comes through fine. I'm getting very frustrated.
    Any ideas?
    I remember looking at a wiring circuit for the 11 speaker system recently... and I am sure there was a remote activation wire from the original radio..

    This pin-out should help... there is definitely a remote required... it turns on the Antenna amplifier and the under seat amp according to Crutchfield.

    1999-2001 Land Rover Discovery with Harmon Kardon Wiring Information

    No idea why your radio is working when nothing else is... this might help your radio reception too... not that it is wonderful on the Disco...lol

  7. #17
    mattg Guest
    The factory unit seems to have 2 antenna plugs one big and one small. What are they for?

  8. #18
    Join Date
    Oct 2013
    Location
    Wodonga
    Posts
    88
    Total Downloaded
    0
    Quote Originally Posted by mattg View Post
    The factory unit seems to have 2 antenna plugs one big and one small. What are they for?
    AFAIK one is for AM and the other is for FM, I think both are amplified when you connect the remote lead.

    There is a schematic for the entertainment system in Rave... I dont have it on this laptop but it should show the connections.

    Possibly talk to a Car Stereo specialist about an adapter.

    This is from the Entertainment section of the PDF....
    "Aerial
    On base and midline ICE systems an AM/FM aerial is built-in to the side window glass on the RH side of the vehicle. An amplifier is located on the frame above the rear side widow behind the rear quarter trim, and is secured (and earthed) with one bolt. Coaxial leads connect the aerial to the aerial amplifier and radio cassette. Power is supplied from the auxilary relay in the engine compartment fuse box, through a fuse in the passenger compartment fusebox to the amplifier."
    "On high line ICE systems two amplified aerials are built-in to the side window glass of the vehicle. The two aerials are an AM/FM aerial on the RH side, and an FM aerial on the LH side. The amplifier for each aerial are located on the frame above each rear side widow behind the rear quarter trim, and are each secured (and earthed) with one bolt. Amplified aerials improve the reception quality, the FM aerial gives improved reception in areas of poor signal (diversity) conditions in urban areas. A Power feed from the radio cassette player is connected to the amplified aerials, power is available when the cassette player is operating. The aerials are connected to the radio cassette player by two coaxial cables, a small plug connects the FM only aerial, a larger plug connects the AM/FM aerial."
    Last edited by Andych; 5th January 2014 at 09:47 AM. Reason: Additional Info

  9. #19
    mattg Guest
    Hmmm. Makes me think that some how I am Turing the audio amp on when I turn on the radio at the same time as turning on the radio amp. I have printed the wiring diagram from rave and have a sparky mate coming over to see if we can nut it out.

  10. #20
    Join Date
    Jul 2010
    Location
    Hunter Valley NSW
    Posts
    750
    Total Downloaded
    0
    The HU iso plug C0098 terminal 5 is the (system enable) remote switch wire to the amp and also suppiles both antenna ampilfiers, This must have 12v when system is on via the HU remote turn-on if equipped.

Page 2 of 3 FirstFirst 123 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!