Thread: Help Damaged ECM

Hi, first go into EMS - programming - immobiliser and follow the steps as to get the message that the security code was learned then in the injectors menu insert the injector codes, if you dont know them you have to remove the rocker cover and read them from the solenoids

Thanks Sierrafery,
It runs but I have no throttle and M & S lights flashing, any Ideas?

you said it's the same year but it was the same transmission?, is yor's manual or auto...what are the part numbers of the original and replacement ECMs?

for throttle the driver demand must be set the same like the first one(2 or 3 track) for M+S usually the setting is in BCU for maunal or auto

Both Autos. Original ECM MSB 101193 replacement MSB 101340. I also have the engine light illuminated as well as M + S flashing

After programming shut down the car, unplug
Lock, wait for 60 seconds and restart

Originally Posted by Pippin

Both Autos. Original ECM MSB 101193 replacement MSB 101340. I also have the engine light illuminated as well as M + S flashing

so the 101340 was removed from a Eu3 modell while your's is Eu2 i think , in EMS programming you'll find the driver demand, set it to 2 track(or way i can't remember exactly) then the MIL and M+S should go away and you can drive it

SHE LIVES!!!!!!!!


Thankyou very much Sierrafery, I don't know what the EU3 ECM was doing in my spare 2001 Discovery, must have been a replacement unless the changeover was earlier than I thought.

the tranzition was at the end of 2001