Thread: Advice about solenoid valve block rear suspension.

So hopefully you can see 2 pictures above. The olive on the tube with the split is ststandard and the one on its own is the type I've used and works fine. I tried 4mm and 5mm push fit for 4mm tube but neither fitted.

You might want to invite "clubagreenie"? He knows about this kind of stuff.

I put a 4 diodes in to improve the logic of the airbag controls, so it goes down now. .
My car has a used standard compressor & solenoid block etc, from a disco 2, a good one from MR automotive. (one pair of solenoids and a dump valve)
on the car;

Both sides can be raised individually or together, by the rocker switches.
Both sides can only be lowered together, ( either or both rocker switches.)


The car will raise 40 mm each 10 seconds, final test height 2000 mm to the roof at the back, from just sitting on the bump stops at 1880 mm, to 2000 mm in 30 seconds), going down is a little slower, I think because of the small pipes used by LR.
When I hold the rocker switches in the up position the car seems to come up fairly level,, and goes down level OK. my normal ride height for around town is about 1980 mm. Pretty happy with the result, and its nearly all landrover bits.

cheers simmo