Thread: I am adding CDL to my 2002. ***** of a job

Phil, next time up go through the prcess of drilling out the rivets, don't bother to install new rivets, use self tapping metal screws to refit the plates. Save you a lot of time next time. ( you know you like to tinker, so you will be under there again )

Re the araldite, heat is a killer, it actually will soften araldite . This is how we released things glued with araldite, we heated it gently and the items came apart. But it might last a while.
I'm sure Kenny outback1 would have a good used Genuine switch.
cheers, Mario

I won't be under there again willingly!LOL

I went camping on the weekend as it is the 25 th anniversary of Disco launch in OZ. So the Range Rover Club had an event near Capertee.

So We had a bit of a 4WD on farm tracks and the difflock was very helpful.

I also took a drive to Turon Gates and then to Sunny Corner.
So far the switch has stayed in place on these rough roads.

Regards Philip A