Results 1 to 6 of 6

Thread: Under Dash drivers side flap

  1. #1
    Join Date
    Dec 2008
    Location
    melbourne
    Posts
    406
    Total Downloaded
    0

    Under Dash drivers side flap

    Hi
    As the heading states I've somehow lost/broken the metal tab that the locking screw fixes the plastic flap onto. Is there an way way to fix this problem? Thought about getting one from a wrecker and Tig weld it back on so it holds the flap properly.
    Cheers
    Luke

  2. #2
    Join Date
    Feb 2009
    Location
    Newborough, VIC
    Posts
    1,540
    Total Downloaded
    67.72 MB
    Sorry, I'm not sure what you mean. I didn't know there was a flap under the dash.
    2002 D2 4.6L V8 Auto SLS+2" ACE CDL Truetrac(F) Nanocom(V8 only)

  3. #3
    Join Date
    Dec 2008
    Location
    melbourne
    Posts
    406
    Total Downloaded
    0
    It's basically the plastic flap that is on the right hand side of the steering column, there is usually a metal tab that the flap fixes onto which has disappeared on my car.....hope this helps😜

    Bronson

  4. #4
    Join Date
    Dec 2008
    Location
    Yatala Vale, Adelaide, SA
    Posts
    340
    Total Downloaded
    0
    I had the same thing happen to the D1. It's a pig to fix neatly in place, it's effectively glued/smooshed into the dash material IIRC, so once broken off it's difficult to reattach.
    I also remember that gluing to the dash material is unlikely to work too well.
    I think I managed to make a small metal tab up that I fixed to the inside that replaced it, but I can't recall how I fixed it to the main dash. I suspect I drilled and put a bolt through.
    If you want a neat job I think you'll need to remove the dash to gain access to the back, then you may be able to weld something on (though how the front will look after the heat... ) or use a short self tapper or two to attach a tab.
    That's a lot of work...
    The other option is to change the panel that opens so the tab is on that and rotates and locks against the dash. In fact I reckon that is the way I'd go, it's only 4 bolts to remove the panel then it's a bit of fab work to make a simple mechanism.

    edit: Kind of like this, but obviously without the big handle on the front, it's the rear mechanism I'm talking about latch
    Last edited by steve_a; 6th October 2016 at 09:15 AM. Reason: adding example image

  5. #5
    Join Date
    May 2012
    Location
    Adelaide Hills, SA
    Posts
    564
    Total Downloaded
    0

    I haven't looked

    LH side one on mine is gone too, I was thinking of creating another and fibre glassing it into place. If the entire panel comes off easily as suggested it would make it easier, you could ensure perfect alignment by closing the latch to get it right.

    Mike

  6. #6
    Join Date
    Dec 2008
    Location
    melbourne
    Posts
    406
    Total Downloaded
    0
    So
    After a closer inspection....as stated by others there's actually a plastic tab that is normally under the dash which the tongue normally latches to. Looks like I might have to try source another one and reattach it somehow

    Cheers
    Bronson

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!