Washer pump.

Quote:

---

Originally Posted by AK83

Yeah, as my D2 is a long term project, ATM it's disconnected at the pump.

The nanocom has a body outputs test for the washers/wipers in the BCU page. Is how I remember testing it, once I fitted all the connections and pumps and cleared all the blockages out when I was doing that part of the front end.

---

Little thread dig here.[bigwhistle] Thanks for the info on the Nanocom for checking the outputs from the BCU as I have a dead washer pump for the windscreen so this will narrow down the switch at least.

Quote:

---

Originally Posted by AK83

The nanocom has a body outputs test for the washers/wipers in the BCU page.

---

It does??? Haven't found that one yet. I'd better not play around in there, or I'll activate the smokescreen or self deflating tyres.

Quote:

---

Originally Posted by wobblygts

Little thread dig here.[bigwhistle] Thanks for the info on the Nanocom for checking the outputs from the BCU as I have a dead washer pump for the windscreen so this will narrow down the switch at least.

---

Don't search that function cos the only pump which can be activated with nanocom is the headlamp power wash, the other two pumps are not covered.

Quote:

---

Originally Posted by sierrafery

Don't search that function cos the only pump which can be activated with nanocom is the headlamp power wash, the other two pumps are not covered.

---

Yeah, my bad ... it probably was the headlamp pump I tested(fitted to my project D2) .. and I must have mis-remembered the test.