Thread: 3 Amigos wiring

Originally Posted by ozie

can the ECU be repaired or needs to be replaced (NNN)
I've added the long leads, worked on the front but no difference to the rear

That "NNN" is about the engine ECU not about the SLABS. Everything can be repaired by specialists but the second hand SLABS ECUs are not so expensive

mmm Ive already swapped out the Slabs for an 03/04 version - Nanocom still shows 0 on R/R

Originally Posted by sierrafery

then you'll have to get the the SLABS ECU plug and measure resistance across the relevant pins, C0505 - 4/5(RH front) and 3/6 (RH rear) if you get open circuit you'll have to check the sensor's resistance in it's plug and if that's OK(between 950-1100 ohm) there is a wiring issue somewhere, if the sensor is open it's obvious to replace it but if you get that resistance in the ECU plug then the ECU is fubar

- anyone which ones ro connect to for lh side
thanks

Originally Posted by ozie

- anyone which ones ro connect to for lh side
thanks

same connector pins 1-2 front, 7-8 rear