Thread: D2 Tow Bar/RepairSeals/SvcManual & other Questions

Phew...take a breath landyprincess and welcome aboard.

Your towbar is the standard LR supplied and is rated to tow up to 3500 kg. All very strong and you will not have any problems with it.

The tongue, that is the 'long bit with the ball on the end' can be picked up from any tow bar manufacturer OR you can get the OEM one from LR for about $150. This kit from LR includes the wiring so if you want to rewire to make it all original you could. The problem you may have with the non LR tongue is to ensure you have the drop the right height. It can be difficult to get it right.


Your wiring is only a generic 7 pin flat plug that is available everywhere. You can now even get adapters pre made so you can change from flat to round, 7 to 5 pin ect so just pop down to Supercheap as they have a good range.


The manual can be purchased from here and it supports this magnificent site. Just click the link and order away. They are brilliant.

AULRO Classifieds - Message - Powered by PhotoPost Classifieds


The airbags were rated to be changed at 10 years. Since then I believe there is a LR Service Bulletin that has pushed this out to 15 years.

Q.
I don't know what manufacturer make/model/weight this will take. Any pointers on where this may be located?

I don't have the towball bit at all so the above will help me to know what it is so I can get one. I've uploaded a pic, that may make it easier. Perhaps by first glance some of you may know already what make/manufacture it is? Otherwise, happy to go clambering under the rear to find info :-)

Hayman Reece tongue will fit, MAX weight over the ball or downward pressure is 250KG and max weight you can tow is 3.500KG.

--------
Towbar Wiring
--------
I've always been use to seeing the older round wiring bit that you plug the trailer etc in2, however this one is marked with '7' in a circle and the text LUMEN underneath, with the plug end of the wiring being rectangular etc.

Q.
Any ideas where one can purchase the wiring bit that plugs into the towbar>trailer etc? How much do they normally retail for? Can you pick them up from a wreckers or would it be best to buy new? It it a particular make I need to ask for? Male>female connectore here. I have absolutely no idea!

A; Any trailer place, auto supplier, Supercheap and so on, just ask for the female trailer plug.

------------
Repair Cracked Plastic seal - pls refer to splitseal.jpg
------------

Q. Any pointers on a excellent strength adhesive so I can glue together the plastic seal that is a little split? (This is on the LHS top where the plastic seal starts to go around the bootdoor - again not sure of the terminology here)

A; Super glue

------------
Repair / servicing / maintenance manual
------------

My D2 is a - DISCOVERY II 00.5MY 2000. Any pointers on where one can obtain a repair manual from so hubby/I can do any repair / servicing / maintenance work etc? Any pointers on what's the best one to buy out there and how much they go for? Also, would this manual include operation of all the buttons on the dash! I have no idea what some of them do or how to engage them to work!!

Rave CD from the Markets section of this forum.


Some Vic members can answer the rest

------------
Spare Parts
------------
I have a few things I would like get. Any pointers or links to purchase these items, either second hand/new or any wreckers in Melbourne that specialise in Landrover parts?

1. LHS rear tail light that has a small broken piece missing from the bottom RHS corner. Is the rear taillight one piece or is it 2 pieces?

2. Side steps - any ideas what ones are good, not fussed whethr they are silver in colour or black. Not sure if they came with standard ones as aftermarket product? Is there any special holes to factor in when fitting, any brands etc you could recommend?

3. On the LHS where you have the plastic moulding that curves around the rear side panel that sits ontop of the bumperstep looks like it's missing one clip that it clips into so it sits flush against the panel. Not sure what you call it, but is there a specific clip/screw etc that I need to ask for?

4. On the inside, I think I am missing the panel that sits on the console at the bottom, maybe it is meant to have a picture of the gears and how they work when in 4wd mode?


---------
Airbag Modules Replacement
-----------

I have in the service portfolio/owner info booklet a replacement date for the airbag modules. Any ideas on how much something like this would cost and is it mandatory to get them replaced?

Thanks very much for the response. I know it was a bit of a long post. Sorry!! I have purchased the CD and will wait for that now also - thanks again...

Lolla

Don't know where you are in Melb, but fwiw...

AMV, 515 Maroondah Hwy, Ringwood, 98709904, Peter, Greg or Luke.
If you're not sure of what "that thingo" is, take the car. New and used.

Worth checking out Triumph Rover Spares in Adelaide, too. Got a brand new website. Good people, a bit xxxxy, but great service and delivery. Talk to Phil 08 83846933.

I declare NO ASSOCIATION with either of these groups - I've just had good dealings with them.

HTH

Pete

http://img172.imageshack.us/img172/6089/dscf1280vi3.jpg[/IMG][/URL]
[URL=http://g.imageshack.us/g.php?h=172

The best side steps I've come across are the ARB steps - these are made of steel tubing with aluminium checker plate on the steps.

Steer clear of the plastic or moulded aluminium ones - some of them look nice, but they can't handle any sort of impact and will either bend or break very easily.

Also, some of the steps available require that you remove the black plastic sill guards below the doors on the Disco. These look like crap when fitted, as they do not properly fill the gap left where the original sill guards were.

Great to see another lady d2 driver.....

Do you have any pics of the hole car?

Once you recieve the CD either burn a copy or keep it in the vehicle.
It will be a godsend if you have a breakdown and the nearby mechanic needs more info.
Just hope he has a computer.
Andrew

Hi LandyAndy

The CD is fantastic! Thanks so much for making all that info available. I've learnt a few things about the D2 (and much more I am sure) that I otherwise would have still been scratching my head perplexed at. I see where it gets the RAVE name from, can't rave enough about all the useful info !!! Hubby had a spare tow hitch/ball which believe it or not does fit so I will measure it all up to see that it 'complies' with the addendum bit on the D2 manual. (spare bits off hubby's 'anchor' may come in handy after all - shock horror - hahah). I've already burnt a 'backup cd' incase anything happens to this one and have that stashed away and as technology is such a
grand thing these days have saved a copy of the doc to my SD card and can view that on my IPAQ (or anyone else for that matter - i'm a techno geek too hahah and love my little gadgets!!) I may just keep a 'printed' copy spare in the D2 somewhere also...


Hi twigrx7
funnily enough most of whom I see driving landrovers (melbourne here) whether they be the Td5, V8, V8i, SE etc seem to be female with the odd bloke!! As for the pic - not at the mo. Just stock standard at present with dreams of doing some things in the future...

Cheers
L