Thread: D2 Radio

I would try contacting your local Land Rover Service Centre*. They'll want your VIN number and proof of ownership and they should be able to retireve your code from the database. (Not sure if they charge for this service).




*provided they haven't closed it

There is a test code for Eurovox units which is 1 1 1 1 or 1 1 1 1 1 1 depending on the radio (if it's a 4 digit code or 6 digit code - D2s are usually 4 digit). I assume you have a Eurovox radio.

That will get the radio working for 5 minutes & the display will flash.


The code can be checked via the radio serial number too.

Thanks guys,

Much appreciated Scouse!!!

I tried the pin that was supplied, it was the same one that Range Rov enetered. Unfortunately it does not work.

Apparently when entering it in the numbers should briefly appear on the screen, it's just frozen with code 1 on it and does nothing.

Think a new radio's in order....

Before you condemn the radio, leave it disconnected from power overnight then try it entering the code again.
Also double check that there is permanent power to the radio & also accessory power.

Whereabouts are you located?
I have some D2 radios sitting in my garage if you do get stuck.

scouse,
do the facia lights work on those radios you have?, mine have gone out and not planning to replace just for that!
cheers
yorkie

Originally Posted by YORKIE

scouse,
do the facia lights work on those radios you have?, mine have gone out and not planning to replace just for that!
cheers
yorkie

Yorkie

Have you had your radio out for any reason or done outback touring (ie corrugations)? If so take out the radio and check the connectors at the back of it. Last time I took mine out I didnt have it properly connected and some of the functions may not work including the lights.

Angus

angus,
thanks for that, no outback stuff just stopped lighting up.
i have taken it out to try and figure out how the work and reading here seem to understand the job but cannot be bothered with soldering at this time.
will check again and maybe try the solder job, worse case i buy a replacement for $100 at supercarp.
cheers
yorkie

Originally Posted by Scouse

Before you condemn the radio, leave it disconnected from power overnight then try it entering the code again.
Also double check that there is permanent power to the radio & also accessory power.

Whereabouts are you located?
I have some D2 radios sitting in my garage if you do get stuck.

Thanks Scouse, I'll definately try the disconnect, i'll do it friday night.

It seems like it's getting power, lights come on and it shows on the screen Code 1, however it's frozen on there.

Will see how I go.

I am located Eastern Suburbs melb (vermont)

Cheers
JB