Results 1 to 5 of 5

Thread: SLS Calibration Blocks

  1. 5th July 2009, 10:56 PM #1
    bluerazor's Avatar
    bluerazor
    bluerazor is offline Fossicker
    Join Date
    May 2009
    Posts
    53
    Total Downloaded
    0

    SLS Calibration Blocks

    Hi To everyone
    A few weeks back i replaced both Rear Height sensors because the connecting link was cracked.
    To replaced them i simply disconnected the battery removed the old ones and fitted the new ones.
    The level seemed approx ok till i was under the car and noticed that the distance of the rear bump stop where diffrent distances approx 1 cm.
    Reading the Rave manual it shows you need sls calibration blocks!!!
    Does anybody have the drawing plans to home make these things?
    Thanks
    Vince
    Reply With Quote Reply With Quote
  2. 5th July 2009, 11:04 PM #2
    p38arover's Avatar
    p38arover
    p38arover is offline Major part of the heart and soul of AULRO.com
    Administrator
    I'm here to help you!     Gold Subscriber
    Join Date
    Jan 1970
    Location
    Western Sydney
    Posts
    30,707
    Total Downloaded
    1.63 MB
    Got a part no. for the blocks?

    Sorry, I just looked it up. I don't have them.
    Ron B.
    VK2OTC

    2003 L322 Range Rover Vogue 4.4 V8 Auto
    2007 Yamaha XJR1300
    Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA



    RIP Bucko - Riding on Forever
    Reply With Quote Reply With Quote
  3. 7th July 2009, 06:21 PM #3
    Ricey's Avatar
    Ricey
    Ricey is offline Master
    Join Date
    Jun 2007
    Location
    Rodd Point, NSW
    Posts
    734
    Total Downloaded
    0
    The blocks are used in conjunction with a nanocom to achieve the correct height setting & set it, as I understand it.

    What I've done is - on a level surface jacked the rear from the towbar to desired height then stored the new heights to the nanocom (somewhere around 130-140) Removed the jack & check heights again. I'm not quite sure if this method is ok but it seems to work.
    Reply With Quote Reply With Quote
  4. 7th July 2009, 07:29 PM #4
    cal415's Avatar
    cal415
    cal415 is offline ChatterBox Supporter
    Join Date
    Jan 1970
    Location
    Stockton, NSW
    Posts
    2,769
    Total Downloaded
    0
    A couple of blocks of wood between the between the axle and the bump stop at the disired height would do the trick!

    Reply With Quote Reply With Quote
  5. 7th July 2009, 10:10 PM #5
    bluerazor's Avatar
    bluerazor
    bluerazor is offline Fossicker
    Join Date
    May 2009
    Posts
    53
    Total Downloaded
    0
    Hi to everyone
    First sorry for the delay but been away for work reasons
    Second thats for the info i'll try with some wooden blocks
    Anyone suggestions what dimensions?
    Many Thanks
    Vince
    Reply With Quote Reply With Quote
« D2 Air Suspension Problems | Snorkel Template?? »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!