Thread: Got my D2!!

Also forgot to mention that i'm going to fit the rear diff centre into the front and run the locker in the rear instead of the front.

Also the list for what else is happening to it;

Putting in/on from my D1;

Uniden UHF,
Warn 9000 pound winch
Maxxis Bighorns 245/75

and in the near future,

TJM bar to fit my winch
Some lightforce xgt's
33" federal mt's
Fridge

Shamo

Nice work, i broke 2 breaker bars removing the axles nuts on my old d2 as well,, we tried heaps of things including a huge rattle gun... in the end we cut the nut off and replaced it with a new one.

That diff damage is ugly!! bloody amazing the CWP is ok.... make sure you check it right over for nicks etc as anything like that could weaking it or cause some noise.

What a great looking truck! ...except for the front diff...

Will you need a bigger lift to fit the 33s?

W

Your right Cal, we took that diff out just in time, the CWP is still good, gave it a good look over. A few more kays with the diff like that, and the CWP would have gone I reckon. But it goes to show the importance of the CDL and Low range in offroad situations. The transfer case will not go into low range, still trying to fix that. So the previous owner, must have done quite a bit of offroad work in high range and with no CDL.
With the traction control working over time, it must have put a lot of strain on the diff, so it eventually gave up. I would recommend the CDL as the first modification for a d2 as it is just so important.
As far as I know (don't quote me on that) the axles and CV's in D2's are stronger than D1 and RRC axles due to the addition of traction control, but if only they made the hemisphere stronger.
But I guess it gives him a good excuse to put the ARB in.

Waz, you can run 33's with only a 2 inch lift without cutting the guards, but you need to fit rock sliders as they rub on the plastic sill covers.

So I guess Shamo now you can help me pull out my front diff as it has been humming away for ages, could knock up some sliders at the same time, see how we go...

Thanks for the comments guys, does anyone know weather or not i have to change the joints where the tail shafts attach to the diff centres? or will they be the same front and back?

Also does anyone know how much a rebuild of a transfer case would cost? its looking like i may need one...

Shamo

Congratulations on the purchase Shamo... guess she'll be ready to play at Coffs

Originally Posted by Outlaw

Congratulations on the purchase Shamo... guess she'll be ready to play at Coffs

Thanks mate, i bloody hope it will be! wont be ready for the meeting tmrw night though sadly, i'm marooned in Toowoomba at the moment haha.

Shamo

Well done shamo, great lookin rig. Amazing what a wash could do!!!
Good luck with everything.