Thread: Got one!

Originally Posted by Baffle

haha well done.



2, your lucky, this is your after market CDL that some poor previous owner had to get installed because it was not included in this model.

Not sure about this, the CDL is controlled by the lever used for low range, it is a square pattern and CDL can be operated in both high and low range on my 2004 d2a.

Not sure what your switch is for, you will just have to try to operate to find out what it does. For safety reasons, only do it when stationary.
Brian

Pics are up one the show us your D2 thread.

http://www.aulro.com/afvb/discovery-...ml#post1186003

Jeff

Originally Posted by Brian

Not sure about this, the CDL is controlled by the lever used for low range, it is a square pattern and CDL can be operated in both high and low range on my 2004 d2a.

Not sure what your switch is for, you will just have to try to operate to find out what it does. For safety reasons, only do it when stationary.
Brian

My model is the 02 and I got the AMV after market cdl actulator installed, they fit in place of the coin tray and have a switch with a light saying In/out. 03 and after Landrover re introduced the cdl again

I crawled under yesterday to trace where the switch goes. Apart from getting my eyes full of dust I saw they appear to go to an actuator on top of the centre diff. The wires were disconnected. Not having been under a Disco before I didn't know what I was looking at, perhaps I'll look under my Defender to see if it is the same centre diff, the transfer case looks the same.

Jeff