Thread: EVO2 Nano Instrument Mode

Yes you can by defining the start up mode

ill double check on that, i know the nanocom 1 has a startup mode, but i dont recall seeing anything on the EVO for startup mode.
maybe i need firmware update

Nanocom - Setup - Start up Settings

as shown in their manual [ame]http://nanocom-diagnostics.com/downloads/1404979031.pdf[/ame]

so whats the code for TD5 D2 instrument mode, there all just random so i need to know which to use. i dound this section before but couldnt work out which to use for TD5 instruments

ps thanks for the manual, i never got one

scroll down, and select td5inst, save

You'll still need to plug it in to power up, at least mine doesn't auto on. But mine has other issues ATM.Remember leave the unit end plugged and screwed in and use the OBD port end as your "switch".

I tried to use a 12v external source from both the power socket and a switched fuse source but needed a bump to start from the OBD signal. once on it would however stay on even when the engine was shut down and show ECU loss of signal when it powered down.

I leave mine permanently connected in the D2a. Switches off automatically after a period (most times), and to switch it on, I just hold my finger gently against the screen for a few seconds after starting the engine. Likewise, if it freezes (which it does intermittently), I just hold my finger on the screen until it beeps/goes off, and it then self starts a few seconds later. Alternatively disconnect the cable at the car OBDII end and reconnect.

If I transfer the unit to the RRC/MY99 TD5 it works most times, but wont switch off when I turn off. Given that we still have a few minor electrical issues to address when Dave comes back from up north, this may be an interim issue.