Thread: Disco 2, only idles, no throttle and m&s flashing

Hi Cameron

Try the following thread for starters.

https://www.aulro.com/afvb/electroni...ult-codes.html

The nanocom will also include a brief description with the code, which will assist in working out what the number means. You can save the error codes to an SD card as a text file and then cut and here to save typing.

Cheers

Steve

Seems like throttle position sensor failure

Originally Posted by sierrafery

Seems like throttle position sensor failure

Thanks for your reply, I changed the TPS and re wrote it to the ECU. Still same fault. Idles only m&s flashing, amber engine light on limp home mode ... Checked for oil in loom. About over it!

But if you have tester why didn't you check live inputs from the TPS before you replaced it? cos it can be a wiring issue between it and the ECU or it can give inputs then you knew more.... i should have said "TPS signal failure", sorry

I had a similar failure and it turned out to be the auto box selector switch (XYZ switch). I know you said gear box but some people use the term generically.

If you are able to clear the code and make the S&M lights disappear, more the selector and see if the lights come on instantly. That is more or less how I diagnosed it.

Check the wiring loom that connects the XYZ switch and transfer case switches to the main harness under the center console. Look for chafing of the loom where it runs across the top of the transfer case and loose multi-pin connectors.

Thanks everyone for their help and suggestions. The problem was caused by the wire that runs between the head and firewall and connects to the oil cooler on the passenger side of the engine, being chafed and shorting out. The corrugated insulating plastic around it had broken down.
As soon as I insulated it, all the warning lights went off and the accelerator worked.
I now have a spare accelerator and crank angle sensor!

Cameron