URGENT NANOCOM HELP

tyreplus4x4 · 25th October 2009, 02:27 PM

I have just been installing nanocom and trying to work out functions with ignition on the red light in speedo came on the engine light with a stroke through it comes on when i try to start engine there is nothing apart from horn beeping twice and no power, all lights and acc work what have i done.

Tombie · 25th October 2009, 02:50 PM

unplug nanocom, lock car, wait 5 min...

come back and unlock.

See if it starts.. if not, post again!

tyreplus4x4 · 25th October 2009, 03:14 PM

Originally Posted by Tombie2

unplug nanocom, lock car, wait 5 min...

come back and unlock.

See if it starts.. if not, post again!

Hi Mike i did what you said but no luck,the red light in the speedo flashes when door closed and stays on when door open with no ignition on,it also stays on when ignition on.
Hope you can help Thanks George

**dmdigital** · 25th October 2009, 03:34 PM

Check the Disco's battery charge. It's probably dropped below 11.5V. If so charge it up and retry.

tyreplus4x4 · 25th October 2009, 03:36 PM

Originally Posted by dm_td5

Check the Disco's battery charge. It's probably dropped below 11.5V. If so charge it up and retry.

Sorry mate it is a Defender and both batteries are fully charged.

Cheers George

**dmdigital** · 25th October 2009, 04:22 PM

Must look at the avatar picture next time

Have you got the EKA for the Defender? If so try using that.

tyreplus4x4 · 25th October 2009, 05:01 PM

Originally Posted by dm_td5

Must look at the avatar picture next time

Have you got the EKA for the Defender? If so try using that.

No there is no EKA

**LandyAndy** · 25th October 2009, 09:02 PM

I wonder if you accidentley changed the security coding whilst exploring.
Have you used a laptop with Nanocom??? Just makes it a bit easier to use.
Go into the TD5 motor section,click learn security code(or similar,cant exactly remember how its worded) it will re-sync the imobiliser in the ECU.
If this dont work,post again.
GOODLUCK
Andrew

tyreplus4x4 · 26th October 2009, 06:11 AM

Originally Posted by LandyAndy

I wonder if you accidentley changed the security coding whilst exploring.
Have you used a laptop with Nanocom??? Just makes it a bit easier to use.
Go into the TD5 motor section,click learn security code(or similar,cant exactly remember how its worded) it will re-sync the imobiliser in the ECU.
If this dont work,post again.
GOODLUCK
Andrew

Hi Andrew i did what you said but still the same the nanocom does say the imobiliser is on.
Thanks George

**bluerazor** · 26th October 2009, 09:02 PM

Hi
just a quick question but did you by any reason change the EKA code
while playing with the Nanocom?
If so have you tried to "RE-sync" ie by inserting the code with the Keys
in the drivers door? Follow the instructions CAREFULLY from the owners manual.
Good Look
Vince

Thread: URGENT NANOCOM HELP

Thread Tools

URGENT NANOCOM HELP

Bookmarks

Bookmarks

Posting Permissions