Thread: Rear swing away carrier on a rrc. Thoughts and ideas

I did this on my Discovery I. The chassis pick-up points for the bumper are the same on the Range Rover but you have to make a decent bumper to mount the swing out carriers to.
My system can carry two spare wheels...or I can remove one of the wheels and carry two jerry's in it's place if I wish.

Hi there
i have just or should i say almost finished mine i started out with the arb rear bar which came out on some models as standard. i purchased all the necessary parts from ridjidij offroad well worth a look at he is also on the forum. i have managed to fit 2 33inch tyres on the back. ill try post some pics.

I did a similar thing to 91ramjet. I bought an ARB rear step bar which is very solid and will easily hold whatever you have in mind. I had half a wheel carrier from a friend - off a triton or something, then made up a new base, and with a few parts from Rijidij and it works like a charm.

I'll post some pics when it is light.

Cheers - Gav.

My spare carrier. May oneday make another for the other side for jerrys. One 3/4"UNF nut and a small bolt and pivot pin comes out to remove it if needed.

http://www.aulro.com/afvb/discovery-...l-carrier.html

Here's a thread that might be of interest.